Zebra Technologies 2824-Z manual Related Documents

Page 7

Preface

Related Documents

Caution • Warns you of a situation where excessive heat could cause a burn.

Caution • Advises you that failure to take or avoid a specific action could result in physical harm to you.

Caution • Advises you that failure to take or avoid a specific action could result in physical harm to the hardware.

Caution • Advises you need to wear protective eyeware.

Important • Advises you of information that is essential to complete a task.

Note • Indicates neutral or positive information that emphasizes or supplements important points of the main text.

Example • Provides an example, often a scenario, to better clarify a section of text.

Tools • Tells you what tools you need to complete a given task.

Video • (online only) Links to a motion picture that demonstrates a procedure.

Related Documents

The following documents might be helpful references:

•ZPL II® Programming Guide Volume I (part number 45541L) and Volume II (part number 45542L).

•ZebraNet® Wireless Print Server User Guide (part number 13422L)

•ZebraNet 10/100 Print Server User and Reference Guide (part number 47619L-001)

•ZebraNet PrintServer II™ Installation and User Guide (part number 45537L)

•Universal Serial Bus Specification available from the USB Implementation Forum

980531-001 A

LP 2824-Z User Guide

7

Image 7

Contents User Guide Customer Order # 980531-001 a Product Improvements Proprietary StatementFCC Compliance Statement Liability Disclaimer Canadian DOC Compliance StatementLimitation of Liability Contacts PrefaceDocument Conventions Environmental ManagementSupport Related Documents Preface Contents Operations & Options Hello IntroductionWhat’s in the Box? Opening the printer Inspecting the PrinterAfter opening the printer, check the media compartment Reporting Damage Closing the printerIntroduction Modes of Printing Getting StartedAttaching Power Supply Loading Roll Media Adjusting the Roll HoldersPlacing the Roll in the Media Compartment Adjusting the Guides Status Light Power SwitchOperator Controls Feed ButtonPrinting a Test Label Interface Cable Requirements Hooking Up the Printer and ComputerEthernet Interface Requirements Communicating with the PrinterAdjusting the Print Quality Adjusting the Print WidthOperations & Options Thermal Printing Replacing Supplies XA MMP XZ XA JUS XZ Printing in Peel-ModeOperations & Options Printing on Fan-Fold Media Using the Cutter Option Operations & Options Cleaning MaintenancePrint Head Considerations Media Path Considerations Sensors Platen Considerations LubricationRemoval Replacing the PlatenReplacing the Print Head Thermal-Transfer LP Model Replacing the LP Print Head Maintenance Printer is on and in an idle state TroubleshootingResolutions Printer is not receiving powerEither the media or ribbon is out Printer has failed its power on self test PostThere is a shortage of memory Printer is receiving dataPrint head is over temperature Print head is under temperatureFlash memory is not programmed Printed image does not look right Print Quality ProblemsRibbon sensor settings did not print No print on the labelLabel format was sent to, but not recognized by, the printer Manual Calibration Printing a Configuration Label Troubleshooting TestsRecalibration Communications Diagnostics Resetting the Factory Default ValuesFeed Button Modes Power Off Mode Communications Diagnostics ModeBattery Interfaces Universal Serial Bus USB Connector33-34 Parallel InterfaceRx+ ZebraNet PrintServer II for Ethernet NetworksSerial RS-232 Connector Connecting the Printer to a DTE Device Interfaces Page Customer Order # 980531-001A 2004 ZIH Corp