Installation Considerations
This is a list of tools you will need for installing the Power amplifier:
• Voltmeter | • Wire strippers |
• Electric hand drill w/assorted bits | • Battery post wrench |
• 17' (5 m) Red Power Wire | • Wire cutters |
• 12' (4 m) Remote | • Assorted connectors |
• 1.5' (45 cm) Black Grounding Wire | • Wire crimpers |
This section focuses on some of the vehicle considerations for installing your new Power amplifier. Checking your battery and present sound sys- tem, as well as
Before beginning any installation, be sure to follow these simple rules:
1.Be sure to carefully read and understand the instructions before attempting to install the amplifier.
2.For safety, disconnect the negative lead from the battery prior to begin- ning the installation.
3.For easier assembly, we suggest you run all wires prior to mounting your amplifier in place.
4.Route all of the RCA cables close together and away from any high current wires.
5.Use high quality connectors for a reliable installation and to minimize signal or power loss.
6.Think before you drill! Be careful not to cut or drill into gas tanks, fuel lines, brake or hydraulic lines, vacuum lines or electrical wiring when working on any vehicle.
7.Never run wires underneath the vehicle. Running the wires inside the vehicle provides the best protection.
8.Avoid running wires over or through sharp edges. Use rubber or plas- tic grommets to protect any wires routed through metal, especially the firewall.
9.ALWAYS protect the battery and electrical system from damage with proper fusing. Install a fuseholder and appropriate fuse on the +12V power wire within 18” (45 cm) of the battery terminal.
10.When grounding to the chassis of the vehicle, scrape all paint from the metal to ensure a good, clean ground connection. Grounding connec- tions should be as short as possible and always be connected to metal that is welded to the main body, or chassis, of the vehicle.
– 8 –