Zebra Technologies R402 manual Attaching Power Supply

Page 16

Attaching Power Supply

Check the power supply to make certain it is appropriate for your input voltage.

Warning: Use the Zebra-supplied power supply that came with your printer.

Never operate the printer and power supply in an area where they can get wet. Serious personal injury could result!

1.Make sure the power switch is in the off position (down).

2.The DC power supply has a barrel connector on one end that must be inserted into the power supply receptacle on the back of the printer.

3.Insert the separate AC power cord into the power supply.

4.Plug the other end of the cord into an appropriate AC electrical outlet.

Plug

Varies by

Country

Barrel

AC

Power

Connector

Cord

Power

Switch

Power

Supply

Power

Supply

Receptacle

Image 16
Contents R402 Users GuidePage Proprietary Statement Page Contents Operation & Options Appendix 980389-001 Rev. a Introduction HelloWhat’s in the Box? Inspecting the Printer Opening the printerInspecting the Printer Closing the printer Reporting Damage Getting Started Modes of PrintingAttaching Power Supply Loading Roll Media Placing the Roll in the Media CompartmentAdjusting the Guides Using the Optional Media Adapter Plates Install the Take-Up Core Install the Ribbon Supply RollLoading Ribbon Attach and Tighten the Ribbon Auto Calibration Power Switch Operator ControlsFeed Button Status LightPrinting a Test Label Parallel Interface Requirements Hooking Up the Printer and ComputerInterface Cable Requirements Adjusting the Print Width Adjusting the Print DarknessAdjusting the Print Speed Communicating with the PrinterOperation & Options Thermal PrintingAdding a New Transfer Ribbon Replacing SuppliesReplacing a Partially Used Transfer Ribbon Printing in Peel-Mode Printing on Fan-Fold Media Rfid Guidelines Supported Transponders Texas Instruments Tag-it Transponders Philips ICode Transponders Philips ICode BlocksInside Technologies Picotag Transponders Inside Technologies Picotag 2KISO-15693 Transponders ZPL II Commands for Rfid WT Write TagRT Read Tag RT Read Tag RS Rfid Setup RI Rfid Get Tag Unique ID Sample of Rfid Programming WT6FDZebraFS FO100,100A0n,60FN0FS Page Cleaning MaintenanceLubrication Parts List DescriptionPage Replacing the Print Head RemovalCleaning the Print Head Page Troubleshooting ResolutionsPrinter is not receiving power Printer is on and in an idle statePrinter has failed its power on self test Post There is a shortage of memoryPrinter is receiving data Either the media or ribbon is outPrint head is over temperature Print head is under temperatureFlash memory is not programmed Print Quality Problems Ribbon sensor settings did not printNo print on the label Printed image does not look rightLabel format was sent to, but not recognized by, the printer Rfid Symptoms Rfid tags generally not programmedVoid messages are printed across media Nothing is printedManual Calibration Printing a Configuration Label Troubleshooting TestsRecalibration Resetting the Factory Default Values Communications DiagnosticsPower Off Mode Communications Diagnostics Mode Feed Button ModesPhysical Specifications AppendixMedia Specifications Font/Code Specifications Options Parallel Interface Technical Information Page Index Cable calibrationQuality problems Voltage Write tag command Page