Zebra Technologies TLP 2824 manual Printing in Peel-Mode

Page 31

Printing in Peel-Mode
The optional dispenser allows you
to print in “peel-mode” where the
label backing follows a different path and
the labels are presented one at a time for
subsequent placement.
1.	Remove several labels from the
	backing material.
2.	Open the top cover.
3.	Open the dispenser door.
4.	Using a stylus, switch on the
	label-taken sensor.
5.	Insert the backing in front of the peel
	bar and behind the peel roller.
6.	Close the dispenser door.
7.	Close the top cover.
8.	Press the Feed button to advance the
	label.
During the print job, the printer will peel
off the backing and present a single label.
Take the label from the printer so it will
print the next label.
	MOVIE
980485-001A	23

Image 31

Contents Zebra TLP 2824 TM 980485-001A Proprietary Statement Shock Hazard Contents Operation & Options 980485-001A Vii 980485-001A Hello IntroductionWhat’s in the Box? Opening the printer Inspecting the PrinterInspecting the Printer Closing the printer Reporting Damage Related DocumentationModes of Printing Getting StartedAttaching Power Supply Loading Roll Media Adjusting the Roll HoldersPlacing the Roll in the Media Compartment Adjusting the Guides Install the Take-Up Core Install the Ribbon Supply RollLoading Ribbon Attach and Tighten the Ribbon Status Light Power SwitchOperator Controls Feed ButtonMedia Length Sensing Interface Cable Requirements Hooking Up the Printer and ComputerSerial Interface Requirements USB Interface RequirementsParallel Interface Requirements Ethernet Interface RequirementsInternal ZebraNet PrintServer II Ethernet Communications Communicating with the PrinterUniversal Serial Bus USB Communications Parallel CommunicationsSerial Communications CommandAdjusting the Print Quality Adjusting the Print WidthThermal Printing Operation & OptionsAdding a New Transfer Ribbon Replacing SuppliesReplacing a Partially Used Transfer Ribbon Printing in Peel-Mode Printing on Fan-Fold Media Using the Cutter Option 980485-001A Cleaning MaintenancePrint Head Considerations Cleaning Card ConsiderationsMedia Path Considerations Platen Considerations LubricationReplacing the Platen AssemblyRemoval Replacing the Print Head Removal Thermal-Transfer TLP ModelAssembly 980485-001A What the Status Light is Telling You TroubleshootingPrinter Operation Media Handling No print on the label Print Quality ProblemsPrinted image does not look right Label format was sent to, but not recognized by, the printer Manual Calibration Communications Diagnostics Resetting the Factory Default ValuesPrinter Condition Feed Button Action Feed Button ModesAppendix Universal Serial Bus USB ConnectorInterfaces Host Parallel InterfaceInternal Ethernet PrintServer Looking into the Printer’s RJ-45 Modular ConnectorSerial RS-232 Connector Printer Serial RJ-11 Alternative Connector980485-001A Page Page