Zebra Technologies TLP 2824 manual Printing on Fan-Fold Media

Page 32

Printing on Fan-Fold Media
Printing on fan-fold media requires you to
set both the media hangers and the media
guides in position.
1.	Open the top cover.
2.	Open the hangers to their widest
	position.
3.	Snap the holder-open lock towards the
	front of the printer.
4.	With a sample of your media, adjust
	the guides to the width of the media.
	The guides should just touch, but not
	restrict, the edges of the media.
5.	Insert the media through the slot at the
	rear of the printer.
6.	Run the media between the hangers
	and guides.
7.	Close the top cover.
24	980485-001A

Image 32

Contents Zebra TLP 2824 TM 980485-001A Proprietary Statement Shock Hazard Contents Operation & Options 980485-001A Vii 980485-001A Introduction HelloWhat’s in the Box? Inspecting the Printer Opening the printerInspecting the Printer Closing the printer Related Documentation Reporting DamageGetting Started Modes of PrintingAttaching Power Supply Adjusting the Roll Holders Loading Roll MediaPlacing the Roll in the Media Compartment Adjusting the Guides Loading Ribbon Install the Ribbon Supply RollInstall the Take-Up Core Attach and Tighten the Ribbon Power Switch Operator ControlsFeed Button Status LightMedia Length Sensing Hooking Up the Printer and Computer Interface Cable RequirementsUSB Interface Requirements Parallel Interface RequirementsEthernet Interface Requirements Serial Interface RequirementsCommunicating with the Printer Universal Serial Bus USB CommunicationsParallel Communications Internal ZebraNet PrintServer II Ethernet CommunicationsCommand Serial CommunicationsAdjusting the Print Width Adjusting the Print QualityOperation & Options Thermal PrintingReplacing a Partially Used Transfer Ribbon Replacing SuppliesAdding a New Transfer Ribbon Printing in Peel-Mode Printing on Fan-Fold Media Using the Cutter Option 980485-001A Maintenance CleaningMedia Path Considerations Cleaning Card ConsiderationsPrint Head Considerations Lubrication Platen ConsiderationsRemoval AssemblyReplacing the Platen Replacing the Print Head Thermal-Transfer TLP Model RemovalAssembly 980485-001A Troubleshooting What the Status Light is Telling YouPrinter Operation Media Handling Printed image does not look right Print Quality ProblemsNo print on the label Label format was sent to, but not recognized by, the printer Manual Calibration Resetting the Factory Default Values Communications DiagnosticsFeed Button Modes Printer Condition Feed Button ActionInterfaces Universal Serial Bus USB ConnectorAppendix Parallel Interface HostLooking into the Printer’s RJ-45 Modular Connector Internal Ethernet PrintServerSerial RS-232 Connector Serial RJ-11 Alternative Connector Printer980485-001A Page Page