Zebra Technologies TLP 2824 manual Appendix, Interfaces, Universal Serial Bus USB Connector

Page 51

Appendix

Interfaces

Universal Serial Bus (USB) Connector

The figure below displays the cable wiring required to use the printer’s USB interface.

			Pin	Signal

	2	1	1	Vbus - N/C

			2	D-
			2	D-

			3	D+
	3	4
	3	4	4	Ground

			Shell	Shield/
				Drain Wire

For information on the USB interface, go to the USB web site at:

Http://www.usb.org

980485-001A

43

Image 51

Contents Zebra TLP 2824 TM 980485-001A Proprietary Statement Shock Hazard Contents Operation & Options 980485-001A Vii 980485-001A Hello IntroductionWhat’s in the Box? Opening the printer Inspecting the PrinterInspecting the Printer Closing the printer Reporting Damage Related DocumentationModes of Printing Getting StartedAttaching Power Supply Loading Roll Media Adjusting the Roll HoldersPlacing the Roll in the Media Compartment Adjusting the Guides Install the Ribbon Supply Roll Install the Take-Up CoreLoading Ribbon Attach and Tighten the Ribbon Status Light Power SwitchOperator Controls Feed ButtonMedia Length Sensing Interface Cable Requirements Hooking Up the Printer and ComputerSerial Interface Requirements USB Interface RequirementsParallel Interface Requirements Ethernet Interface RequirementsInternal ZebraNet PrintServer II Ethernet Communications Communicating with the PrinterUniversal Serial Bus USB Communications Parallel CommunicationsSerial Communications CommandAdjusting the Print Quality Adjusting the Print WidthThermal Printing Operation & OptionsReplacing Supplies Adding a New Transfer RibbonReplacing a Partially Used Transfer Ribbon Printing in Peel-Mode Printing on Fan-Fold Media Using the Cutter Option 980485-001A Cleaning MaintenanceCleaning Card Considerations Print Head ConsiderationsMedia Path Considerations Platen Considerations LubricationAssembly Replacing the PlatenRemoval Replacing the Print Head Removal Thermal-Transfer TLP ModelAssembly 980485-001A What the Status Light is Telling You TroubleshootingPrinter Operation Media Handling Print Quality Problems No print on the labelPrinted image does not look right Label format was sent to, but not recognized by, the printer Manual Calibration Communications Diagnostics Resetting the Factory Default ValuesPrinter Condition Feed Button Action Feed Button ModesUniversal Serial Bus USB Connector AppendixInterfaces Host Parallel InterfaceInternal Ethernet PrintServer Looking into the Printer’s RJ-45 Modular ConnectorSerial RS-232 Connector Printer Serial RJ-11 Alternative Connector980485-001A Page Page