Zebra Technologies TLP 2824 manual Using the Cutter Option

Page 33

Using the Cutter Option

Printers that have a bezel with a motorized blade can dispense one or more forms that are then automatically cut from the media supply. This option cuts through continuous paper from rolls and liner between labels. Keep the cutter dry. Never use any solutions or solvents to clean the blade.

Use the f command to set the cut position and the C command to cut immediately outside a form.

If the blade cuts through labels, adhesive can jam the cutter.

1. Turn OFF (O) printer power and unplug the power and interface cables before clearing the cutter.

2. After removing debris, plug in the power and interface cables, turn on the printer, then test for normal operation.

980485-001A

25

Image 33

Contents Zebra TLP 2824 TM 980485-001A Proprietary Statement Shock Hazard Contents Operation & Options 980485-001A Vii 980485-001A Hello IntroductionWhat’s in the Box? Opening the printer Inspecting the PrinterInspecting the Printer Closing the printer Reporting Damage Related DocumentationModes of Printing Getting StartedAttaching Power Supply Loading Roll Media Adjusting the Roll HoldersPlacing the Roll in the Media Compartment Adjusting the Guides Install the Ribbon Supply Roll Install the Take-Up CoreLoading Ribbon Attach and Tighten the Ribbon Operator Controls Power SwitchFeed Button Status LightMedia Length Sensing Interface Cable Requirements Hooking Up the Printer and ComputerParallel Interface Requirements USB Interface RequirementsEthernet Interface Requirements Serial Interface RequirementsUniversal Serial Bus USB Communications Communicating with the PrinterParallel Communications Internal ZebraNet PrintServer II Ethernet CommunicationsSerial Communications CommandAdjusting the Print Quality Adjusting the Print WidthThermal Printing Operation & OptionsReplacing Supplies Adding a New Transfer RibbonReplacing a Partially Used Transfer Ribbon Printing in Peel-Mode Printing on Fan-Fold Media Using the Cutter Option 980485-001A Cleaning MaintenanceCleaning Card Considerations Print Head ConsiderationsMedia Path Considerations Platen Considerations LubricationAssembly Replacing the PlatenRemoval Replacing the Print Head Removal Thermal-Transfer TLP ModelAssembly 980485-001A What the Status Light is Telling You TroubleshootingPrinter Operation Media Handling Print Quality Problems No print on the labelPrinted image does not look right Label format was sent to, but not recognized by, the printer Manual Calibration Communications Diagnostics Resetting the Factory Default ValuesPrinter Condition Feed Button Action Feed Button ModesUniversal Serial Bus USB Connector AppendixInterfaces Host Parallel InterfaceInternal Ethernet PrintServer Looking into the Printer’s RJ-45 Modular ConnectorSerial RS-232 Connector Printer Serial RJ-11 Alternative Connector980485-001A Page Page