Zebra Technologies TLP 2824 manual Thermal-Transfer TLP Model, Removal

Page 40

Thermal-Transfer TLP Model
Before following the steps in this		MOVIE
procedure, open the printer by
pulling the release latches forward then
lifting the top cover. Remove any ribbon
from the carriage.
Removal
1.	Grasp the print head spring and pull it
	to the left; then, slide it free of the
	carriage.
2.	Use the spring to pry the print head
	clip off the right side of the carriage.
3.	Pull the print head and bracket
	forward.
4.	Use a #2 Phillips driver to remove the
	screw that holds the ground wire.
5.	Unplug both bundles of print head
	wires from their connectors.
32	980485-001A

Image 40

Contents Zebra TLP 2824 TM 980485-001A Proprietary Statement Shock Hazard Contents Operation & Options 980485-001A Vii 980485-001A Introduction HelloWhat’s in the Box? Inspecting the Printer Opening the printerInspecting the Printer Closing the printer Related Documentation Reporting DamageGetting Started Modes of PrintingAttaching Power Supply Adjusting the Roll Holders Loading Roll MediaPlacing the Roll in the Media Compartment Adjusting the Guides Install the Take-Up Core Install the Ribbon Supply RollLoading Ribbon Attach and Tighten the Ribbon Power Switch Operator ControlsFeed Button Status LightMedia Length Sensing Hooking Up the Printer and Computer Interface Cable RequirementsUSB Interface Requirements Parallel Interface RequirementsEthernet Interface Requirements Serial Interface RequirementsCommunicating with the Printer Universal Serial Bus USB CommunicationsParallel Communications Internal ZebraNet PrintServer II Ethernet CommunicationsCommand Serial CommunicationsAdjusting the Print Width Adjusting the Print QualityOperation & Options Thermal PrintingAdding a New Transfer Ribbon Replacing SuppliesReplacing a Partially Used Transfer Ribbon Printing in Peel-Mode Printing on Fan-Fold Media Using the Cutter Option 980485-001A Maintenance CleaningPrint Head Considerations Cleaning Card ConsiderationsMedia Path Considerations Lubrication Platen ConsiderationsReplacing the Platen AssemblyRemoval Replacing the Print Head Thermal-Transfer TLP Model RemovalAssembly 980485-001A Troubleshooting What the Status Light is Telling YouPrinter Operation Media Handling No print on the label Print Quality ProblemsPrinted image does not look right Label format was sent to, but not recognized by, the printer Manual Calibration Resetting the Factory Default Values Communications DiagnosticsFeed Button Modes Printer Condition Feed Button ActionAppendix Universal Serial Bus USB ConnectorInterfaces Parallel Interface HostLooking into the Printer’s RJ-45 Modular Connector Internal Ethernet PrintServerSerial RS-232 Connector Serial RJ-11 Alternative Connector Printer980485-001A Page Page