B • MAGNETIC ENCODER CLEANING
There exists two different processes to clean the Magnetic stripe Encoder.
The first process consists of a standard cleaning of the printer. This cleans the most important parts of the printer; including the print Head, Transport Roller and Magnetic Stripe Encoder (refer to chapter 4 “Cleaning” for more instructions.)
The second process consist of a cleaning of the Magnetic Encoder using the Menu Button from the LCD Display.
To access the Magnetic Cleaning Menu proceed as below:
1 • Leave power on.
2 • Remove cards from the card feeder.
3 • Insert one presaturated card (provided) through slot on the side of the Card Cartridge.
4 • Press the Menu button until the LCD screen shows CLEANING MENU.
5 • Press the Select button to select.
6 • Press the Menu button again until the LCD screen shows CLEAN MAG HEAD.
7 • Run this operation by pressing the select button.
ISO STANDARD ENCODING
Track # |
| Field Separator | Track density | Valid Characters | # of characters |
|
|
|
|
|
|
1 |
| ^ | 210BPI* | Alphanumeric | 79*** |
|
|
|
| (ASCII 20 - 95**) |
|
|
|
|
|
|
|
2 |
| = | 75BPI* | Numeric | 40*** |
|
|
|
| (ASCII 48 - 62) |
|
|
|
|
|
|
|
3 |
| = | 210BPI* | Numeric | 107*** |
|
|
|
| (ASCII 48 - 62) |
|
* Bit per inch |
|
|
|
| |
** Except the “?” character |
|
|
|
*** Including Start, Stop and LRC characters. Also note that these 3 characters are automatically managed by the magnetic encoder according to the ISO Standard norms.
NOTE: Refer to the Card Printer Programmer’s Manual for complete programming information.
TECHNICAL SPECIFICATION 45