Nortel Networks NN46200-301 manual Power supply installation, Navigation, Power supplies

13

Power supply installation

This guide contains information about installing power supplies.

Navigation

•"Power supplies" (page 13)

•"Removing and installing a power filler panel" (page 17)

•"Installing the AC power supply" (page 18)

•"Removing the AC power supply" (page 20)

Power supplies

The Ethernet Routing Switch 8306 and 8310 chassis have three bays for power supplies. Use the AC power supply for AC input power. The following figure shows an Ethernet Routing Switch 8301AC power supply. The nominal input voltage range for the 8301AC power supply is 100-120 VAC and 200-240VAC, however, the output power is limited to 1140 W maximum at 100-120 VAC nominal input voltage conditions. To obtain full output power (1770 W), you must connect the 8301AC power supply to a 200-240 VAC nominal input voltage source.

Nortel Ethernet Routing Switch 8300

Installation — AC Power Supply

NN46200-301 03.01 Standard

4.027 August 2007

Copyright © 2007, Nortel Networks