|
| Command line interfaces 9 | ||
Table 1 |
|
|
| |
NNCLI command modes |
|
| ||
|
|
|
| |
Command | Prompt | Mode | Command/mode | |
mode | name | to enter or exit mode | ||
| ||||
|
|
|
| |
User EXEC | Exec | Default mode | ||
|
|
| when NNCLI is started | |
|
|
| logout to exit | |
|
|
|
| |
Privileged | privExec | enable to enter | ||
EXEC |
|
| from User EXEC mode | |
|
|
| disable to exit | |
|
|
| to User EXEC mode | |
|
|
|
| |
Global | config | configure to enter | ||
Configuration |
|
| from Privileged EXEC | |
|
|
| mode | |
|
|
| exit to exit | |
|
|
| to Privileged EXEC | |
|
|
| mode | |
|
|
|
| |
Interface | interface to | |||
Configuration |
|
| enter from Global | |
|
|
| Configuration mode | |
|
|
| exit to exit | |
|
|
| to Global Configuration | |
|
|
| mode | |
|
|
|
|
Accessing the NNCLI
When you first power up the Ethernet Routing Switch 8300, the default interface is the Ethernet Routing Switch 8300 CLI. To switch from the CLI to the NNCLI, you must change the NNCLI boot flag to true and save the boot configuration file using the following commands:
ERS-8310:5# config boot flags nncli true
You must reboot the switch for this change to take effect. After you reboot the switch, access the NNCLI using Telnet, rlogin, or the local console port. You can log in to the switch using your password and the default privilege password nortel.
Use the following commands to:
•log in to the software using the default user name and password
•access Global Configuration mode
Login: xxxxx
Password: xxxxx ERS-8310:5> enable
Nortel Ethernet Routing Switch 8300
Installation — AC Power Supply
4.027 August 2007
Copyright © 2007, Nortel Networks