Nortel Networks NN46200-301 manual For instructions, see Removing the AC power supply

Page 19

Installing the AC power supply 19

CAUTION

Save the power filler panel in case you need to operate the 8300 Series chassis with a power supply removed.

2If you are replacing a failed power supply, then remove the failed supply.

For instructions, see "Removing the AC power supply" (page 20).

3Grasp the handle of the new power supply.

4Push the power supply firmly into the bay.

5Tighten the retaining screws until the power supply is seated firmly.

6Connect the power cord to the power supply and to an AC power outlet that is on a circuit with no other equipment connected to it.

Connect each power supply in the chassis to a separate AC circuit.

Nortel Ethernet Routing Switch 8300

Installation — AC Power Supply

NN46200-301 03.01 Standard

4.027 August 2007

Copyright © 2007, Nortel Networks

Image 19
Contents Installation AC Power Supply Statement of conditions Restricted rights legendContents Contents New in this release FeaturesOther changes New in this release Preface Command line interfacesPreface Accessing the Nncli Returning to the CLI Text conventionsItalic text Hard-copy technical manualsHow to get help Power supplies Power supply installationNavigation 8301AC power supply Power supply LEDs State Meaning Power supply installation Step Action Removing and installing a power filler panelInstalling the AC power supply For instructions, see Removing the AC power supply Removing the AC power supply To remove an AC power supply End DC Output Power Ratings Appendix Electrical specifications for the AC power supplyAppendix Electrical specifications for the AC power supply Appendix Electrical specifications for the AC power supply Appendix Electrical specifications for the AC power supply Page Installation AC Power Supply