Nortel Networks NN46200-301 manual Removing the AC power supply

Page 20

20Power supply installation

7Turn on the power switch.

The power supply LED on the power supply should light green.

—End—

Removing the AC power supply

DANGER

Due to high-energy hazards of working with components of greater than 240 VA, only qualiﬁed service personnel are permitted to install and replace Ethernet Routing Switch 8300 components.

You can remove a redundant power supply without affecting the operation of the Ethernet Routing Switch 8300 Series switch. When you remove a power supply, the LED on the power supply turns off, and the Ethernet Routing Switch 8300 Series Chassis automatically redistributes the load to the remaining power supplies.

Nortel Ethernet Routing Switch 8300

Installation — AC Power Supply

NN46200-301 03.01 Standard

4.027 August 2007

Copyright © 2007, Nortel Networks

Image 20

Contents Installation AC Power Supply Restricted rights legend Statement of conditionsContents Contents Other changes FeaturesNew in this release New in this release Command line interfaces PrefacePreface Accessing the Nncli Text conventions Returning to the CLIHard-copy technical manuals Italic textHow to get help Navigation Power supply installationPower supplies 8301AC power supply Power supply LEDs State Meaning Power supply installation Removing and installing a power ﬁller panel Step ActionInstalling the AC power supply For instructions, see Removing the AC power supply Removing the AC power supply To remove an AC power supply End Appendix Electrical speciﬁcations for the AC power supply DC Output Power RatingsAppendix Electrical speciﬁcations for the AC power supply Appendix Electrical speciﬁcations for the AC power supply Appendix Electrical speciﬁcations for the AC power supply Page Installation AC Power Supply