Updating/Sending Configuration to RTU
This section assumes the system is connected.
Pressing the “Get Setup Information From Device” will request information from the respective RTU you are connected to.
Once pressed, the MAIN form will remove data from all respective data fields and replace them with refreshed data.
Pressing the “Send Changes To Device” will force the information located within the data fields into the respective RTU’s internal configuration.
!WARNING! Be sure that all the respective data fields are filled with the correct data. If a parameter is left blank the system will interpret the data as a ZERO “0”. This may cause your system to fail if parameter such as the ID or RF network is set incorrectly. Confirm all configuration data by requesting data from the respective RTU or Press the Disconnect then Connect to update and view the most current data.
Manual Documentation Number: | 45 |
B&B Electronics Mfg Co Inc – 707 Dayton Rd - PO Box 1040 - Ottawa IL 61350 - Ph
Third Party Communications Protocol Support
Third party communications support was added to allow for different type of communications protocols such as Modbus RTU, etc. As we develop and enhance support of other protocols we will
To select a communications type, click on the communications type bar, select the type of communications then “Send Parameters To Device”.
Communications Type
46 | Manual Documentation Number: |
B&B Electronics Mfg Co Inc – 707 Dayton Rd - PO Box 1040 - Ottawa IL 61350 - Ph