Intermec PB50 manual Where xxxxxxxxxx is a value between 8 and 64 characters

Chapter 2 — Configuring the PB50

To configure the printer to use WEP authentication

1Send the following commands to login as an admin and set the SSID:

run"su -p pass admin"

setup write "wlan","uart1:" setup "wlan","SSID","xxxxx"

where xxxxx can be from 0 to 32 ASCII characters, not including the double quote.

Note: The default password for logging in as an admin is “pass.” If you have changed the password, you will need to use your password instead of “pass.”

2Send the following commands to configure the WEP keys. The following example sets WEP key 1 to 1234 and enables WEP key 1.

setup "wlan","WEP1","0x0001020304" setup "wlan",".WEP_KEY","1" setup "wlan","ACTIVE","1"

setup write "wlan","uart1:"

To configure the printer to use WPA-PSK or WPA2-PSK mode

1Send the following commands to login as an admin and set the SSID:

run"su-p pass admin"

setup write "wlan","uart1:" setup "wlan","SSID","xxxxx"

where xxxxx can be from 0 to 32 alphanumeric characters.

2Send one of the following WPA/WPA2 ON commands to turn on WPA or WPA2 authentication. Send the WPA-PSK or WPA2-PSK command to set a pre-shared key:

setup "wlan","WPA","ON" setup "wlan","WPA2","ON"

setup "wlan","WPA_PSK","xxxxxxxxxx" setup "wlan","ACTIVE","1"

setup write "wlan","uart1:"

where xxxxxxxxxx is a value between 8 and 64 characters.

To configure the PB50 to use WPA or WPA2 Enterprise mode

1Send the following commands to login as an admin and set the SSID: