ATEN Technology PN9108U user manual Safety Instructions, General

Page 4

PN9108U User Manual

Safety Instructions

General

MRead all of these instructions. Save them for future reference.

MFollow all warnings and instructions marked on the device.

MDo not place the device on any unstable surface (cart, stand, table, etc.). If the device falls, serious damage will result.

MDo not use the device near water.

MDo not place the device near, or over, radiators or heat registers.

MThe device cabinet is provided with slots and openings to allow for adequate ventilation. To ensure reliable operation, and to protect against overheating, these openings must never be blocked or covered.

MThe device should never be placed on a soft surface (bed, sofa, rug, etc.) as this will block its ventilation openings. Likewise, the device should not be placed in a built in enclosure unless adequate ventilation has been provided.

MNever spill liquid of any kind on the device.

MUnplug the device from the wall outlet before cleaning. Do not use liquid or aerosol cleaners. Use a damp cloth for cleaning.

MThe device should be operated from the type of power source indicated on the marking label. If you are not sure of the type of power available, consult your dealer or local power company.

MThe device is equipped with a 3-wire grounding type plug. This is a safety feature. If you are unable to insert the plug into the outlet, contact your electrician to replace your obsolete outlet. Do not attempt to defeat the purpose of the grounding-type plug. Always follow your local/national wiring codes.

MDo not allow anything to rest on the power cord or cables. Route the power cord and cables so that they cannot be stepped on or tripped over.

MIf an extension cord is used with this device make sure that the total of the ampere ratings of all products used on this cord does not exceed the extension cord ampere rating. Make sure that the total of all products plugged into the wall outlet does not exceed 15 amperes.

iv

2005-09-07

Image 4
Contents PN9108U Regulatory Information User Notice Safety Instructions General2005-09-07 Rack Mounting Power Cord Power CordsPower Outlet Cords Package Contents Contents Administration Safe Shutdown and RebootUpgrading The Firmware AppendixAbout This Manual OverviewGetting Help ConventionsAltusen Information Technical SupportProduct Information Altusen Authorized ResellersXiv Introduction OverviewFeatures Optional Capability Requirements Hardware Setup Front ViewPower LED Rear View RS-232 PortPower Switch Before you Begin InstallationStacking Phillips hex head M3 x Hardware Setup Single Stage Installation Hardware Setup Daisy Chaining Browser Operation LoggingPN9108U Main Screen Device Selector Device ControlPower Buttons Power Status ScreenTop Panel Reboot Information PanelBottom Panel Administration Working Environment ConfigurationSystem Information AdministratorConnection Control Network Fixed IP AddressDynamic IP Address Date / Time Firmware LogoutPower Management Configuration ConfigurationHeading Meaning This function disables the Reboot checkbox on the main Outlet Groups UPSPN9108U Schedule User Management Monitor Log 2005-09-07 Safe Shutdown and Reboot Automated Setup InstallationUninstalling Manual Setup Windows 2000 / XP / ServerSafe Shutdown and Reboot 2005-09-07 Upgrading The Firmware PreparationStarting the Upgrade IP Address Determination MethodMethod Arp -s ip address PN9108U’s MAC address Problem TroubleshootingSolution Problem Problem Administrator Login Failure Specifications Function SpecificationBattery Replacement Limited Warranty Index 2005-09-07