Chapter 2.
Hardware Setup
Front View
1 | 2 | 3 | 4 | 5 | |||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
6 | 7 | 8 | 9 |
1. Port LEDs
The Port LEDs provide status information about their corresponding AC outlet ports. There is one pair of LEDs for each port. The one on the left is the Remote Access LED; the one on the right is the Power LED:
MA Remote Access LED lights GREEN to indicate that the device attached to its corresponding port is capable of being controlled remotely.
MA Power LED lights ORANGE to indicate that there is electricity going to its corresponding outlet. The LED flashes under the following conditions:
MIf Modem Ring Resume is enabled (see p. 28), the outlet still receives electricity even when it is OFF. The Power LED blinks OFF, then ON for 8 seconds, then repeats this sequence to indicate this situation.
MWhen a power status change is pending, the LED flashes until the change has taken place.
MIf both LEDs flash it indicates that there is either an overcurrent situation, or the relay has failed. See Flashing Lightbulb, p. 18, for more details.
2.Current LED
Lights to indicate that the current status (in amps) is being displayed on the Station ID LED (instead of the Station ID).
5