Installation—Accessories
If you use more than one sensor per rack, route the sensor cord farthest from the middle of the
Note rack first. When routing the sensor cord closest to the middle of the rack, secure all sensor cords in the wire tie.
7.With the door fully open, thread the sensor cords through the opening in the front post of the rack.
aem0076a
8.Route the cords between the vertical support rail and the side panel. Each
To install sensors in another location:
1.Use one of the following methods, depending on the type of surface on which you are mounting the sensor:
To mount the sensor on a wall or other smooth surface, peel the backing off the adhesive of the sensor mount, and place the sensor mount onto the wall.
To mount the sensor on a rough wall or porous surface, first install the wall anchor. Then attach the adhesive sensor mount to the wall anchor using the provided
2.Thread a wire tie through the sensor mount, and secure the sensor with the tie. Tighten the wire tie and trim any excess.
Neatly route the sensor cord and connect the sensor to the APC device.
3.Thread a wire tie through the sensor mount, and secure the sensor with the tie. Tighten the wire tie and trim any excess.
4.Neatly route the sensor cord and connect the sensor to the Main Module or TH Module.
8 | Temperature/Humidity Module |