American Power Conversion 5000I user manual Low Battery Warning Interval

Page 13

Low Battery Warning Interval

By default, the low battery warning occurs when there are approximately two minutes of on-battery run time remaining. This may not be enough time to gracefully shut down some protected computer systems.

To change the warning interval, press the rear panel configuration button while pressing and holding the front-panel on/test button.

2 min. The initial setting.

5 min. Press the configuration button once to set the low battery warning interval to approximately five minutes.

7 min. Press it again to set the interval to approximately seven minutes. Press the button a third time to reset the interval to two minutes.

7	990-7032A, Revision 3 7/01

Image 13

Contents 990-7032A, Revision 3 7/01 990-7032A, Revision 3 7/01 Electrical Safety Handling SafetyReplacement and Recycling of Batteries Page Table of Contents Page How to Unpack the UPS ContentsIntroduction UnpackingPlacement InstallationInstalling Rack Mount Units Position the UPSInstall the Mounting Rails in the Rack Load the UPS into the Rack Hardwire the Electrical ConnectionConnect Power and Equipment to the UPS Install the BatteriesConnect Power to the UPS Install PowerChute and AccessoriesInitial Startup Low Battery Warning Interval Operating Instructions Storage Replacing the Battery How to Determine On-Battery Run Time User Configuration ItemsUPS battery life differs based on usage and environment Tower and 5U Rack Mount 5000 VA ModelsSpecifications Regulatory Agency Approvals Troubleshooting Limited Warranty ServiceIf the UPS requires service do not return it to the dealer APC Contact InformationRack Type Hole Type Hardware Required Hardware Included RacksAppendix B Transporting Your Smart-UPS