Epson TM-T88II Series DIP Switch and Paper Near End Settings A-3, Print Density Selection

Page 43

Print Density Selection

Print Density		SW 2-3	SW 2-4

1 Low power consumption mode		ON	ON

2	(Normal)	OFF	OFF

3		ON	OFF

4	(Dark)	OFF	ON

Notes:

•With the optional RS-485 interface, DIP switches 2-7 and 2-8 are disabled.

•Changes in DIP switch settings (excluding switches 2-7 and 2-8 interface reset signals) are recognized only when the printer power is turned on or when the printer is reset by using the interface. If the DIP switch setting is changed after the printer power is turned on, the change does not take effect until the printer is turned on again or is reset.

•If you turn on DIP switch 2-7 or 2-8 while the printer is turned on, the printer may be reset, depending on the signal state. DIP switches should not be changed while the printer power is on.

•If the print density is set to level 3 or 4, the printing will be at low speed.

•In a low power consuption, printing speed is fixed to 70 mm/sec.

DIP Switch and Paper Near End Settings A-3

Image 43

Contents TM-T88II Series Der Thermalkopf ist heiß Printer Parts and LabelsLabels Thermal head is hot La téte thermique est chaudeSolving Problems Installing and Replacing PaperQuick Reference Page Product Name TM-T88II Model Name M129B EMC and Safety Standards AppliedIii FCC Compliance Statement CE MarkingFor American Users Gereäuschpegel About This Manual Setting Up and UsingReference Application Software FeaturesIntroduction PrintingViii Introduction Options and AccessoriesContents Appendix a DIP Switch and Paper Near End Settings Setting Up the Printer Setting Up the PrinterUnpacking Connecting the computer Connecting the Cables and Grounding the Printer2Setting Up the Printer Connecting the Drawer Anschließen der Schublade 4Setting Up the PrinterGrounding the Printer Connecting the Power SupplyPage Installing or Replacing the Paper Roll 8Setting Up the Printer Tear off the paper as shown Running the self test Using the Power Switch Cover10Setting Up the Printer Self TestSelf test printing Please press the Paper Feed button 12Setting Up the Printer Adjustments and SettingsControl Panel Using the PrinterUsing the Printer Operating the Control PanelPanel lights 2Using the PrinterPrinting problems TroubleshootingTroubleshooting General problems2Troubleshooting Error light is off, but nothing is printedPrinting is poor Paper handling problems Cleaning the print headPaper is jammed inside the printer 4Troubleshooting Auto cutter is jammed Auto cutter problems6Troubleshooting Hexadecimal Dump 8Troubleshooting Reference Information Printing SpecificationsReference Information 2Reference Information Line spacing default 4.23 mm 1/6Paper roll Paper SpecificationsSingle-ply Current Electrical CharacteristicsConsumption at Life TemperatureReliability Environmental Conditions6Reference Information Serial interface specifications DIP Switch and Paper Near End SettingsSetting the DIP Switches DIP switch functions2DIP Switch and Paper Near End Settings Print Density Selection DIP Switch and Paper Near End Settings A-34DIP Switch and Paper Near End Settings Parallel interface specificationsDIP Switch and Paper Near End Settings A-5 6DIP Switch and Paper Near End Settings Changing the DIP switch settingsDIP Switch and Paper Near End Settings A-7 Adjusting the Paper Near End Detector1999.12