Epson TM-T88II Series user manual DIP Switch and Paper Near End Settings A-5

Page 45

Notes:

•Changes in DIP switch settings (excluding switch 2-8 interface reset signal) are recognized only when printer power is turned on or when the printer is reset using the interface. If the DIP switch setting is changed after printer power is turned on, the change does not take effect until the printer is turned on again or is reset.

•If you turn on DIP switch 2-8 while the printer is turned on, the printer may be reset, depending on the signal state. Do not change DIP switches while the printer power is on.

•If the print density is set to level 3 or 4, the printing will be at low speed.

•In a low power consumption, printing is fixed to 70 mm/sec.

DIP Switch and Paper Near End Settings A-5

Image 45

Contents TM-T88II Series Labels Printer Parts and LabelsThermal head is hot La téte thermique est chaude Der Thermalkopf ist heißInstalling and Replacing Paper Solving ProblemsQuick Reference Page EMC and Safety Standards Applied Product Name TM-T88II Model Name M129BIii CE Marking FCC Compliance StatementFor American Users Gereäuschpegel Setting Up and Using About This ManualReference Introduction FeaturesPrinting Application SoftwareViii Introduction Options and AccessoriesContents Appendix a DIP Switch and Paper Near End Settings Setting Up the Printer Setting Up the PrinterUnpacking Connecting the Cables and Grounding the Printer Connecting the computer2Setting Up the Printer Connecting the Drawer Anschließen der Schublade 4Setting Up the PrinterGrounding the Printer Connecting the Power SupplyPage Installing or Replacing the Paper Roll 8Setting Up the Printer Tear off the paper as shown 10Setting Up the Printer Using the Power Switch CoverSelf Test Running the self testSelf test printing Please press the Paper Feed button 12Setting Up the Printer Adjustments and SettingsUsing the Printer Using the PrinterOperating the Control Panel Control PanelPanel lights 2Using the PrinterTroubleshooting TroubleshootingGeneral problems Printing problemsError light is off, but nothing is printed 2TroubleshootingPrinting is poor Cleaning the print head Paper handling problemsPaper is jammed inside the printer 4Troubleshooting Auto cutter is jammed Auto cutter problems6Troubleshooting Hexadecimal Dump 8Troubleshooting Printing Specifications Reference InformationReference Information 2Reference Information Line spacing default 4.23 mm 1/6Paper Specifications Paper rollSingle-ply Electrical Characteristics CurrentConsumption at Reliability TemperatureEnvironmental Conditions Life6Reference Information Setting the DIP Switches DIP Switch and Paper Near End SettingsDIP switch functions Serial interface specifications2DIP Switch and Paper Near End Settings Print Density Selection DIP Switch and Paper Near End Settings A-34DIP Switch and Paper Near End Settings Parallel interface specificationsDIP Switch and Paper Near End Settings A-5 6DIP Switch and Paper Near End Settings Changing the DIP switch settingsDIP Switch and Paper Near End Settings A-7 Adjusting the Paper Near End Detector1999.12