Epson TK14 operation manual Appendix F, Appendix a

FENIX IMVICO					TK14 OPERATION MANUAL
ESC t n
[Name]	Select character code table
[Formato]	ASCII	ESC	t	n
	Hex	1B	74	n
	Decimal	27	116	n
[Range]	n=<00>H , n = <11>H
[Description]	Selects page n from the character code table.
	n		Page

0PC437 (U.S.A., standard Europe)

17 PC866 (Cyrillic)

[Default]	n = 0
[Reference]	APPENDIX F
ESC SP n
[Name]	Set right-side character spacing
[Format]	ASCII	ESC	SP	n
	Hex	1B	20	n
	Decimal	27	32	n
[Range]	<00>H ≤ n≤	<FF>H
[Description]	Sets the character spacing for the right side of the character to [n x 0.125 mm
	(n x 0.0049”)].
[Notes]

•The right side character spacing for double-width mode is twice the normal value. When characters are enlarged, the right-side character spacing is n times normal value.

•This command is effective only when sent at the beginning of a line.

[Default]	n = <04>H
[Reference]	APPENDIX A
ESC ! n
[Name]	Select print mode(s)
[Format]	ASCII	ESC	!	n
	Hex	1B	21	n
	Decimal	27	33	n
[Range]	<00>H ≤ n ≤	<FF>H

[Description] Selects print mode(s) using n as follows:

Bit	OFF/ON	Hex	Function
0	OFF	00	Character font A (12 x 24).
	ON	01	Character font B (8 x 16).
1	--	--	Undefined.
2	--	--	Undefined.
3	OFF	00	Emphasized mode not selected.
	ON	08	Emphasized mode selected.
4	OFF	00	Double-height mode not selected.
	ON	10	Double-height mode selected.
5	OFF	00	Double-width mode not selected.
	ON	20	Double-width mode selected.
6	--	--	Undefined.
7	--	--	Undefined.

[Notes]

•When both double-height and double-width modes are selected, quadruple-size characters are printed.

•When some characters in a line are double or more height, all the characters in the line are aligned at the baseline.

•ESC M can also select character font type. However, the setting of the last received command is effective.

•GS ! can also select character size. However, the setting of the last received command is effective.

33/65