FENIX IMVICO |
|
|
|
|
|
|
| TK14 OPERATION MANUAL | |
FS p n m |
|
|
|
|
|
|
|
|
|
[Name] | Print NV bit image |
|
|
|
|
|
| ||
[Format] | ASCII | FS | p | n | m |
|
| ||
| Hex | 1C | 70 | n | m |
|
| ||
| Decimal | 28 | 112 | n | m |
|
| ||
[Range] | n = 1 |
|
|
|
|
|
|
| |
| 0 ≤ m ≤ 3, <48>H ≤ | m ≤ < 51>H |
|
|
| ||||
[Description] | Prints a NV bit image n using the mode specified by m. | ||||||||
|
|
|
|
|
|
|
|
|
|
|
| m | Mode |
|
| Vertical |
| Horizontal |
|
|
|
|
|
|
| Dot Density | Dot Density |
| |
|
| 0, 48 | Normal |
|
| 203.2 dpi |
| 203.2 dpi |
|
|
| 1, 49 |
| 203.2 dpi |
| 101.6 dpi |
| ||
|
| 2,50 |
| 101.6 dpi |
| 203.2 dpi |
| ||
|
| 3,51 | Quadruple |
|
| 101.6 dpi |
| 101.6 dpi |
|
[dpi: dots per 25.4 mm]
•n is the number of the NV bit image (always 1).
•m specifies the bit image mode.
[Notes]
•NV bit image means a bit image which is defined in a
•This command is not effective when the specified NV bit image has not been defined.
•This command is effective only when there is no data in the print buffer.
•This command is not affected by print modes (emphasized,
•If the printing area width set by GS L for the NV bit image is less than one vertical line, the following processing is performed only on the line in question. However, in NV bit image mode, one vertical line means 1 dot in normal mode (m = 0, 48H) and in
➀The printing area width is extended to the right in NV bit image mode up to one line vertically. In this case, printing does not exceed the printable area.
➁If the printing area width cannot be extended by one line vertically, the left margin is reduced to accommodate one line vertically.
•If the downloaded
•This command feeds dots (for the height n of the NV
•After printing the bit image, this command sets the print position to the beginning of the line and processes the data that follows as normal data.
[Reference] FS q, GS v 0
43/65