Epson TK14 operation manual Justification, ABC Abcd Abcde, ESC c 3 n, OFF / on

FENIX IMVICO				TK14 OPERATION MANUAL
ESC a n
[Name]	Select justification
[Format]	ASCII	ESC	a	n
	Hex	1B	61	n
	Decimal	27	97	n
[Range]	0 ≤ n ≤ 2, 48 ≤	n ≤ 50
[Description]	Aligns all the data in one line to the specified position
	n selects the justification as follows:

nJustification

0, 48 Left justification 1, 49 Centering

2, 50 Right justification

[Notes]

•The command is enabled only when processed at the beginning of the line.

•This command executes justification in the printing area.

[Reference]	ESC !
[Example]
	Left justification	Centering	Right justification

ABC

ABCD ABCDE

ABC

ABCD

ABCDE

ABC

ABCD ABCDE

ESC c 3 n

[Name]	Select paper sensor(s) to output paper end signals (PE in parallel interface)
[Format]	ASCII	ESC	c	3	n
	Hex	1B	63	33	n
	Decimal	27	99	51	n
[Range]	0 ≤ n ≤ 255

[Description] Selects the paper sensor(s) to output paper end signals.

	Each bit of n is used as follows:
		Bit	OFF / ON	Hex	Function
		0	OFF	00	Paper roll near-end sensor disabled
			ON	01	Paper roll near-end sensor enabled
		1	OFF	00	Paper roll near-end sensor disabled
			ON	02	Paper roll near-end sensor enabled
		2	OFF	00	Paper roll end sensor disabled
			ON	04	Paper roll end sensor enabled
		3	OFF	00	Paper roll end sensor disabled
			ON	08	Paper roll end sensor enabled
		4-7	-	-	Undefined
[Notes]	The command is available only with a parallel interface and is ignored with a serial interface.

•It is possible to select multiple sensors to output signals. Then, if any of the sensors detects a paper end, the paper end signal is output.

•Sensor is switched when executing this command. The paper end signal switching be delayed depending on the receive buffer state.

•If either bit 0 or bit 1 is on, the paper roll near-end sensor is selected as the paper sensor outputting paper-end signals

•If either bit 2 or bit 3 is on, the paper roll end sensor is selected as the paper sensor outputting paper-end signals.

•When all the sensors are disabled, the paper end signal always outputs a paper present status.

[Default] n = 12

36/65