36 | Section 4: Management & Configuration | AXIS 1610 User’s Manual |
|
|
|
Using Netspot
The Canon NetSpot utility provides easy network management of your devices by allowing you to set up those devices and display device status and features.
Installing NetSpot Before installing NetSpot, refer to the NetSpot user documentation, provided with the NetSpot software, with information on the installation procedure and the minimum requirements for NetSpot.
Viewing AXIS 1610 As NetSpot communicates with the AXIS 1610 via the TCP/IP using NetSpot protocol (and SNMP), it is necessary to configure the TCP/IP
settings of the AXIS 1610 as described in Assigning an IP address, on page 16. Alternatively, you can configure these settings using NetSpot as follows:
1.Start NetSpot.
2.From the Device menu, select New...
3.Type the MAC address (Ethernet address) of the AXIS 1610 and the IP address you want to assign to the AXIS 1610, and select the Continue... button.
4.Select the frame type of your TCP/IP network, and click the Add to List button.
Notes: ❏ If you want to configure the TCP/IP settings of the AXIS 1610 using NetSpot, it is necessary to use the Administrator version of NetSpot. See the NetSpot user documentation for more information.
❏If you use DHCP, RARP or BOOTP for the IP address, use a temporary IP address in step 3 of the procedure. Reconfigure the TCP/IP settings after completing the procedure.