Canon AXIS 1610 user manual Using the Test Button, Factory Default, Settings

Page 49

AXIS 1610 User’s Manual

Section 4: Management & Configuration

49

 

 

 

Using the Test Button

The test button is located on the front right hand side of the AXIS 1610 and is used for resetting the AXIS 1610 parameters to the factory default settings.

Factory Default

Follow the instructions below to reset the AXIS 1610 to the

Settings

factory default settings:

 

1.

Remove the external power supply to switch off the AXIS 1610.

 

 

2.

Press and hold down the test button, while you plug the external

 

 

power supply back in. Continue to hold down the test button,

 

 

until the network indicator begins to flash at one second

 

 

intervals. This should take at least 5 seconds.

 

3.

Release the test button and wait until the network indicator

 

 

flashes at least five times.

 

4.

Press and hold the test button again until the network indicator

 

 

remains constantly lit.

 

5.

Restart the AXIS 1610 by disconnecting and reconnecting the

 

 

external power supply.

 

The AXIS 1610 is now reset to factory default settings.

Note:

All parameters except the IP Address (IP_ADDR.) and the DHCP

 

 

Enable/Disable (DHCP_ENB) parameters are reset. If you want to

change these parameters, please use any of the tools presented in Configuration Overview, on page 32.

Image 49
Contents Axis For Canon Capt Printers Safety Notices About this manual PrefacePreface Internet Mail Australia SwedenBenelux ChinaAxis 1610 User’s Manual Contents Introduction SectionSupported Environments Where to use itInstallation and Integration How to use itConfiguration and Management Printing ProtocolsFeatures and Benefits Product Overview Package ContentsAxis 1610 Physical Description Product Overview Axis 1610 User’s Manual Connecting a printer to the Network InstallationBefore you start Assigning an IP addressAssigning a BootpInstallation Axis 1610 User’s Manual Example Type the following commandsExample Using Bootp in Unix Installation Axis 1610 User’s Manual Using Installing Printer Ports using Axis Print MonitorInstall and manage a printer using Axis Print Monitor Axis Print MonitorWindows 95/98 Windows ME Installing Printers for Printing over TCP/IPAxis 1610 User’s Manual Installation Using Axis Print Monitor Windows NT Windows XP Axis 1610 User’s Manual Installation Using Axis Print Monitor Windows 95/98 Windows ME Installing printers for Printing over NetBIOS/NetBEUIUsing Axis Print Monitor Windows NT Starting the Installation Basic Setup with Axis NetPilotAxis 1610 User’s Manual Installation Management & Configuration Using a Web browser Home page of your Axis 1610 appears in your browser Overview Using Netspot Using Axis NetPilot Property pages Parameter values parameter valuesAxis 1610 parameters Parameter List EditorModifying the network environments Choose Edit Parameter List from the Setup menuCreating a printer group Adding a printer to a printer group Examining printers Grouping logically connected Print ServersAxis NetPilot Printer Information window Additional information Editing the config Using FTPFile Example View the status file using your preferred text editor Axis MIB Using SnmpManagement & Configuration Axis 1610 User’s Manual Factory Default Using the Test ButtonSettings Upgrading the Firmware Axis NetPilot Upgrade Wizard IPX/SPXAxis 1610 User’s Manual Upgrading the Firmware Appendix a The Parameter List Logged in to the Axis 1610 using rootAppendix B Technical Specifications Dimensions Power ConsumptionWeight SecurityAppendix C Glossary Appendix C Glossary Axis 1610 User’s Manual Axis 1610 User’s Manual Appendix C Glossary