50 | Section 5: Upgrading the Firmware | AXIS 1610 User’s Manual |
|
|
|
Section 5 Upgrading the Firmware
You can upgrade the AXIS 1610 firmware in the flash memory using one of the following methods:
•FTP (TCP/IP)
•AXIS NetPilot Upgrade Wizard (IPX/SPX)
Note: ❏ Updating instructions are also supplied with the software update.
Upgrading over the To upgrade over the network using FTP you will need the file Network using FTP with the new print server software. The name of this file is in the
form product_version.bin, e.g. 1610_580.bin for software release 5.80. You can download the print server software from the Axis web site at http://www.axis.com
Note: ❏ You must assign the AXIS 1610 with an IP address, as described in Assigning an IP address, on page 22, before you can use this upgrading method.
Follow the procedures below to upgrade the AXIS 1610:
1.Log in to the AXIS 1610 with the command:
ftp <host name>, or ftp <IP address>
2.You will be prompted for user id and password. Default user id: root
Default password: pass
3.To change to binary transfer mode, type the command: binary
4.Type the command:
put <software name> flash
(<software name> is the name of the new print server software, e.g. 1610_580.bin)