Toshiba TDP-B1 warranty Turning Off the Projector

Page 16

S e t t i n g	u p	t h e	P r o j e c t o r

NOTE: Lamp life will be extended if you turn the lamp off, then wait 1 minute while the lamp cools before unplugging the projector. The Lamp LED will light green when the lamp has cooled. See page 16 for details on the Lamp LED.

Turning Off the Projector

If you want to turn off the projector for a short period of time, press the standby button on the keypad or remote. This blanks the screen for fifteen minutes, but keeps the projector running. (You can change the amount of time the projector stays in standby mode; see “Standby Time” on page 23 for details.) After 15 min- utes, the lamp goes out (the projector keeps running). To exit standby mode, press the standby button again. (It may take sev- eral seconds for the projection lamp to reach full power and project the image again.)

To completely power off the projector, unplug it. If you want to turn the lamp back on immediately, you must allow about a minute for the lamp to cool. The lamp won’t light if it’s too hot.

12

Image 16

Contents Table of Contents Appendix IndexSafety Instructions F e t y S t r u c t i o n s Image Resolution IntroductionCompatibility Unpacking the ProjectorT r o d u c t i o n Usage Guidelines Warranty If You Need AssistanceSetting UP the Projector T t i n g O j e c t o r Connecting a Computer T t i n g O j e c t o r Connecting a Video Player Audio Adapter Composite video cable Audio cableCable Powering up the Projector and Adjusting the Image Turning Off the Projector Basic Image Adjustment Using the ProjectorUsing the Remote Control I n g O j e c t o r Adjusting the Projector Using the Keypad and Remote Buttons Standby Using the On-Screen Menus Display Menu Audio Menu Image Menu I n g O j e c t o r Position and Vert. Position Controls Menu Rear Projection Language Menu Status Menu Cleaning the Lens Maintenance & TroubleshootingReplacing the Projection Lamp Pull the lamp door up and remove it Lift and grasp the pull tab and lift the module out Figure Replacing the Batteries in the Remote Control Using the Kensington LockTroubleshooting Problem Nothing on projection screen Problem Color or text not being projectedProblem The screen resolution is not right Problem Image isn’t centered on the screenProblem Image is too wide or narrow for screen Problem Image is out of focus Problem Image and menus are reversed left to rightProblem no sound Problem Image is noisy or streakedProblem Lamp seems to be getting dimmer Problem Lamp shuts offSpecifications AppendixAccessories Standard Accessories ship with the projectorProjectors.toshiba.com Portable Computer Activation Chart Key command to Computer Activate port De-activate portFN-F6 FN-F4 FN-F1 NCR Wyse Software driven Zenith FN-F10 Using Video Mirroring with a PowerBook Computer Projected Image Size Index D e Page TDP-B1 Limited Warranty Part Number Safety Certifications Declaration of Conformity