Toshiba TDP-B1 warranty Usage Guidelines

Page 7

speaker

keypad

zoom ring

	Kensington Lock
focus ring	connector panel
focus ring
	power
	cord
	connector
	FIGURE 2

Side view of projector

Usage Guidelines

•Do not look directly into the projection lens when the lamp is turned on. The bright light may harm your eyes.

•Do not block the grills on the projector. Restricting the air flow can cause it to overheat and turn off. If this happens, you must wait a minute before attempting to turn it back on.

•Handle the projector as you would any product with glass components. Be especially careful not to drop it.

•Avoid leaving the projector in direct sunlight or extreme cold for extended periods of time. If this happens, allow it to reach room temperature before use.

•Transport the projector in a vendor-approved hard or soft case. Refer to your Toshiba dealer or projectors.toshiba.com for more information.

3

Image 7

Contents Table of Contents Index AppendixSafety Instructions F e t y S t r u c t i o n s Unpacking the Projector Image ResolutionIntroduction CompatibilityT r o d u c t i o n Usage Guidelines If You Need Assistance WarrantySetting UP the Projector T t i n g O j e c t o r Connecting a Computer T t i n g O j e c t o r Audio Adapter Composite video cable Audio cable Connecting a Video PlayerCable Powering up the Projector and Adjusting the Image Turning Off the Projector Basic Image Adjustment Using the ProjectorUsing the Remote Control I n g O j e c t o r Adjusting the Projector Using the Keypad and Remote Buttons Standby Using the On-Screen Menus Display Menu Audio Menu Image Menu I n g O j e c t o r Position and Vert. Position Controls Menu Rear Projection Language Menu Status Menu Cleaning the Lens Maintenance & TroubleshootingReplacing the Projection Lamp Pull the lamp door up and remove it Lift and grasp the pull tab and lift the module out Figure Using the Kensington Lock Replacing the Batteries in the Remote ControlProblem Image isn’t centered on the screen Troubleshooting Problem Nothing on projection screenProblem Color or text not being projected Problem The screen resolution is not rightProblem Image is too wide or narrow for screen Problem Image is noisy or streaked Problem Image is out of focusProblem Image and menus are reversed left to right Problem no soundProblem Lamp shuts off Problem Lamp seems to be getting dimmerAppendix SpecificationsStandard Accessories ship with the projector AccessoriesProjectors.toshiba.com Key command to Computer Activate port De-activate port Portable Computer Activation ChartFN-F6 FN-F4 FN-F1 NCR Wyse Software driven Zenith FN-F10 Using Video Mirroring with a PowerBook Computer Projected Image Size Index D e Page TDP-B1 Limited Warranty Part Number Safety Certifications Declaration of Conformity