Toshiba TDP-B1 warranty Lift and grasp the pull tab and lift the module out Figure

Page 33

6Lift and grasp the pull tab and lift the module out (Figure 21).

pull tab

FIGURE 21

Removing the lamp module

7Install the new lamp module, being sure to align the connec- tors properly.

8Push the module in until it is flush with the bottom case of the projector.

9Tighten the screws on the outside of the module.

10Replace the lamp door by inserting the hooks on the rear of the lamp door into the projector and pressing the lamp door into place. If the lamp door does not fit properly or bulges out, remove the door and re-seat the lamp module.

11Plug in the power cord to turn the projector back on.

12To reset the lamp hour counter in the Status window, press and hold the volume - button, then press the menu button (while still holding down the volume - button) for 5 seconds. Verify that the counter was reset by pressing the menu button and viewing the counter in the Status window.

WARNING: Do not drop the lamp module or touch the glass bulb! The glass may shatter and cause injury.

29

Image 33
Contents Table of Contents Index AppendixSafety Instructions F e t y S t r u c t i o n s Introduction Image ResolutionCompatibility Unpacking the ProjectorT r o d u c t i o n Usage Guidelines If You Need Assistance WarrantySetting UP the Projector T t i n g O j e c t o r Connecting a Computer T t i n g O j e c t o r Audio Adapter Composite video cable Audio cable Connecting a Video PlayerCable Powering up the Projector and Adjusting the Image Turning Off the Projector Using the Projector Basic Image AdjustmentUsing the Remote Control I n g O j e c t o r Adjusting the Projector Using the Keypad and Remote Buttons Standby Using the On-Screen Menus Display Menu Audio Menu Image Menu I n g O j e c t o r Position and Vert. Position Controls Menu Rear Projection Language Menu Status Menu Maintenance & Troubleshooting Cleaning the LensReplacing the Projection Lamp Pull the lamp door up and remove it Lift and grasp the pull tab and lift the module out Figure Using the Kensington Lock Replacing the Batteries in the Remote ControlProblem Color or text not being projected Troubleshooting Problem Nothing on projection screenProblem The screen resolution is not right Problem Image isn’t centered on the screenProblem Image is too wide or narrow for screen Problem Image and menus are reversed left to right Problem Image is out of focusProblem no sound Problem Image is noisy or streakedProblem Lamp shuts off Problem Lamp seems to be getting dimmerAppendix SpecificationsStandard Accessories ship with the projector AccessoriesProjectors.toshiba.com Key command to Computer Activate port De-activate port Portable Computer Activation ChartFN-F6 FN-F4 FN-F1 NCR Wyse Software driven Zenith FN-F10 Using Video Mirroring with a PowerBook Computer Projected Image Size Index D e Page TDP-B1 Limited Warranty Part Number Safety Certifications Declaration of Conformity