Toshiba TDP-B1 warranty Appendix, Specifications

Page 39

APPENDIX

Specifications

The TDP-B1 must be operated and stored within the temperature and humidity ranges specified.

Temperature
Operating	50 to 104° F (10 to 40° C)
Non-operating	-4 to 158° F (-20 to 70° C)
Humidity

Operating and non-oper.	5% to 95% relative humidity, non-condensing

Dimensions

8.75 x 9.75 x 2.5 inches (22.2 x 24.8 x 6.4 cm)

Weight

4.8 lbs. (2.2 kg) unpacked

Altitude

Operating	0 to 10,000 feet (3,048 meters)
Non-operating	0 to 40,000 feet (12,192 meters)
Optics

Focus Range	4.9 - 16 feet (1.5-5 m)
Lamp

Type	120-watt VHP lamp

Input Power Requirements

100-120VAC 6A;50/60Hz

200-240VAC 3A; 50Hz

Audio Input

Input Impedance	10K ohm nominal, AC coupled
Maximum Input Voltage	(LIN + RIN)PEAK < 4.5 V for THD ≤ 0.3%
	LIN or RIN < 2.0 Vrms for THD ≤ 0.3%
Sensitivity	100 mV at 1 KHz for 88 dB SPL at 1 meter
Connector Type	3.5 mm (1/8 inch) stereo phone mini

35

Image 39

Contents Table of Contents Index AppendixSafety Instructions F e t y S t r u c t i o n s Unpacking the Projector Image ResolutionIntroduction CompatibilityT r o d u c t i o n Usage Guidelines If You Need Assistance WarrantySetting UP the Projector T t i n g O j e c t o r Connecting a Computer T t i n g O j e c t o r Audio Adapter Composite video cable Audio cable Connecting a Video PlayerCable Powering up the Projector and Adjusting the Image Turning Off the Projector Using the Projector Basic Image AdjustmentUsing the Remote Control I n g O j e c t o r Adjusting the Projector Using the Keypad and Remote Buttons Standby Using the On-Screen Menus Display Menu Audio Menu Image Menu I n g O j e c t o r Position and Vert. Position Controls Menu Rear Projection Language Menu Status Menu Maintenance & Troubleshooting Cleaning the LensReplacing the Projection Lamp Pull the lamp door up and remove it Lift and grasp the pull tab and lift the module out Figure Using the Kensington Lock Replacing the Batteries in the Remote ControlProblem Image isn’t centered on the screen Troubleshooting Problem Nothing on projection screenProblem Color or text not being projected Problem The screen resolution is not rightProblem Image is too wide or narrow for screen Problem Image is noisy or streaked Problem Image is out of focusProblem Image and menus are reversed left to right Problem no soundProblem Lamp shuts off Problem Lamp seems to be getting dimmerAppendix SpecificationsStandard Accessories ship with the projector AccessoriesProjectors.toshiba.com Key command to Computer Activate port De-activate port Portable Computer Activation ChartFN-F6 FN-F4 FN-F1 NCR Wyse Software driven Zenith FN-F10 Using Video Mirroring with a PowerBook Computer Projected Image Size Index D e Page TDP-B1 Limited Warranty Part Number Safety Certifications Declaration of Conformity