Toshiba TDP-B1 warranty Setting UP the Projector

Page 9

SETTING UP THE PROJECTOR

1Place the projector on a flat surface.

The projector must be within 10 feet (3 m) of your power source and within 6 feet (1.8 m) of your computer.

If you want to project from behind a translucent screen, set up the projector behind your screen. See “Rear Projection” on page 24 to reverse the image.

2Position the projector the desired distance from the screen.

The distance from the lens of the projector to the screen and the zoom setting determine the size of the projected image. Figure 3 shows three projected image sizes. For more infor- mation about image size, see “Projected Image Size” on page 44.

 

1

 

3

 

.

 

0

 

f

 

t

 

.

 

7

 

.

 

8

3

f

t

.

.

2

 

f

 

t

 

.

 

 

20 ft.

5 ft.

12 ft.

 

FIGURE 3

Projected image size at minimum zoom

3Make sure the projector is unplugged and your computer is turned off.

5

Image 9
Contents Table of Contents Index AppendixSafety Instructions F e t y S t r u c t i o n s Introduction Image ResolutionCompatibility Unpacking the ProjectorT r o d u c t i o n Usage Guidelines If You Need Assistance WarrantySetting UP the Projector T t i n g O j e c t o r Connecting a Computer T t i n g O j e c t o r Audio Adapter Composite video cable Audio cable Connecting a Video PlayerCable Powering up the Projector and Adjusting the Image Turning Off the Projector Using the Projector Basic Image AdjustmentUsing the Remote Control I n g O j e c t o r Adjusting the Projector Using the Keypad and Remote Buttons Standby Using the On-Screen Menus Display Menu Audio Menu Image Menu I n g O j e c t o r Position and Vert. Position Controls Menu Rear Projection Language Menu Status Menu Maintenance & Troubleshooting Cleaning the LensReplacing the Projection Lamp Pull the lamp door up and remove it Lift and grasp the pull tab and lift the module out Figure Using the Kensington Lock Replacing the Batteries in the Remote ControlProblem Color or text not being projected Troubleshooting Problem Nothing on projection screenProblem The screen resolution is not right Problem Image isn’t centered on the screenProblem Image is too wide or narrow for screen Problem Image and menus are reversed left to right Problem Image is out of focusProblem no sound Problem Image is noisy or streakedProblem Lamp shuts off Problem Lamp seems to be getting dimmerAppendix SpecificationsStandard Accessories ship with the projector AccessoriesProjectors.toshiba.com Key command to Computer Activate port De-activate port Portable Computer Activation ChartFN-F6 FN-F4 FN-F1 NCR Wyse Software driven Zenith FN-F10 Using Video Mirroring with a PowerBook Computer Projected Image Size Index D e Page TDP-B1 Limited Warranty Part Number Safety Certifications Declaration of Conformity