Toshiba TLP-ET1E Remove the battery cover, Insert dry cell batteries, Put back the battery cover

Preparations

Preparing and using the remote control

Loading batteries into the remote control	Operating the remote control
Remove the battery cover.	Point the remote control toward the projector's
	infrared remote sensor, and press a button on the
	remote control.
	• Operating the projector from the front

English

Insert dry cell batteries.

Check the positive and negative terminals of each battery to load it correctly.

Use two AAA (LR03 or R03) dry cell batteries.

Put back the battery cover.

Approx. 15°

Approx.5m

•Operating the projector from the rear

Approx. 15°

Approx.5m

Operations Preparations Before Using

●Dry cell batteries

•Remove the batteries from the remote control when it is not used for an extended period of time.

•If the remote control stops working or its controlling range decreases, replace all the batteries with new ones.

●The remote control

•The remote control may fail to operate if the infrared remote sensor is exposed to bright sunlight or fluorescent lighting.

•Do not drop or bang it.

•Do not leave it in hot or humid locations.

•Do not get it wet or place it on top of wet objects.

•Do not take it apart.

•In rare cases, ambient conditions could impede the operation of the remote control. If this happens, point the remote control at the main unit again, and repeat the operation.

Maintenance

Others

13