Operations
Turning the power on and off
Before turning the power on
Connect the power cord.
qInsert the power cord connector into the AC IN socket on the
projector.
wInsert the power cord plug into a wall or other power outlet.
When the power cord is plugged in, the ON indicator comes on in orange, indicating that the unit is on standby.
ON LAMP TEMP FAN
(Supplied) Power cord | (Orange) | |
connector | ||
Lit | ||
|
Remove the lens cover.
Be sure to remove the lens cover when the power is turned on. If it is left on, it could become deformed due to heat.
LCD Panels
LCD panels wear out. In order to prolong the lifetime of your LCD panel, take the following precautions:
•In order to extend the lifetime of the LCD panel, always turn off the power when not in use, and make sure that the lamp is off. Keeping the lamp off is also very effective at saving electricity.
•If the air filter becomes dirty and clogged, the projector’s internal temperature will rise, shortening the lifetime of
the LCD panel and causing malfunctions. Clean the air filter from time to time (see 
p.40), and replace it periodically. Contact the store where you purchased your projector, or your local Service Station for replace- ment of the air filters.
The projector’s LCD panel is made using extremely advanced technology, but there may be black spots (pixels that do not light) or bright spots (pixels that are constantly lit) on the panel. Please note that these are not malfunctions.
English
Maintenance Operations Preparations Before Using
Others
17