1 |
PRINTING FROM WINDOWS |
|
Basic printing | (part 2) |
If the tray runs out of paper during printing
Printing will automatically resume when paper is loaded in the tray.
When using the bypass tray, select printer mode with the mode select key on the machine, load paper as instructed by the message in the display, and then press the [START] key to resume printing.
When the
Note that if the "AUTO TRAY SWITCH" setting in the user programs is enabled and there is the same size of paper in another tray, the machine will automatically switch to the other tray and continue printing.
When "Paper Source" is set to "Auto Select"
If "Paper Source" is set to "Auto Select" in the "Paper" tab of the printer driver setup screen and the correct size of paper for a print job is not loaded in the machine, the printing procedure will vary depending on the "FORCED OUTPUT" setting in the user programs (see "USER PROGRAMS" in the Operation Manual).
When "FORCED OUTPUT" is set to "OFF"
Select printer mode with the mode select key on the machine, check the message in the display, load paper in the bypass tray, and then press the [START] key to begin printing.
When "FORCED OUTPUT" is set to "ON"
Printing takes place on the paper loaded in the machine, even though the paper size is different from the print image size.
Cancel a print job
To cancel a print job that is already in progress, select printer mode with the mode select key on the machine and then press the [CLEAR] key ( 
) or the [CLEAR ALL] key (
). "CANCEL PRINT JOB?" will appear in the display. Select "YES" and press the [ENTER] key.
C O N T E N T S | I N D E X | 7 |
|
|
|