Toshiba B-EP2DL manual Replacing the Platen Ass’y

Page 28

2. MAJOR UNIT REPLACEMENT

EO18-33024

(Revision Date: Dec. 16, 2008)

2.10 Replacing the Platen Ass’y

2.11 Replacing the Platen Ass’y

1)Remove the Upper Sensor Cover. (Refer to Section 2.9 Replacing the Media Sensor (Upper).)

2)Release the Hooks, then remove the Platen Ass’y.

Platen Ass’y

Hook

Hook

3)Replace the Platen Ass’y with a new one, then reassemble in the reverse order of removal.

NOTES:

1.After replacing the Platen, refer to the Setting Operation Manual or System Mode Manual and perform the following operations.

zPerform a RAM clear.

2.Perform a test print and make sure printing is even. (Refer to Section 4.6 in the System Mode Manual.) If the printing is uneven, make sure the platen ass’y is surely fixed with the hooks.

2-24

Image 28
Contents EP2DL Series Page Table of Contents Procedure ChecksMajor Unit Replacement Replacing the CPU PC BoardMajor Unit Replacement Remove the Front Cover Major Unit Replacement Good Right Side Cover EO18-33024 Revision Date Dec Replacing the CPU PC Board Replacing the LCD Unit Replacing the Peel-off Roller Replacing the Peel-off Sensor Peel-off Sensor Unit ZPerform the sensor adjustment Replacing the Stepping Motor EO18-33024 Replacing the Stepping Motor Replacing the Drive PC Board EO18-33024 Replacing the Battery Terminal Replacing the Print Head Major Unit Replacement Replacing the Cover Open Switch and Media Sensor Lower Major Unit Replacement Major Unit Replacement Replacing the Media Sensor Upper Perform a RAM clear Perform the sensor adjustment Replacing the Platen Ass’y Troubleshooting Troubleshooting
Related manuals
Manual 28 pages 23.72 Kb