Toshiba B-415 owner manual CE Compliance for EU only, FCC Notice

Page 2

CE Compliance (for EU only)

This product complies with the requirements of EMC, Low Voltage and R&TTE Directives including their amendments.

FCC Notice

This equipment has been tested and found to comply with the limits for a Class B digital device, in accordance to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Redirect or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

Consult the dealer or an experienced radio/TV technician for help.

Changes or modifications not expressly approved by manufacturer for compliance could void the user's authority to operate the equipment.

CAUTION

To avoid injury, be careful not to catch or jam your fingers while opening or closing the cover.

CAUTION

Do not touch moving parts. To reduce the risk that fingers, jewelry, clothing, etc., be drawn into the moving parts, push the switch in the “O” position to stop movement.

“This Class B digital apparatus meets all requirements of the Canadian Interference-Causing Equipment Regulations.”

“Cet appareil numérique de la classe B respecte toutes les exigences du Règlement sur le matériel brouilleur du Canada.”

(for CANADA only)

IrCOMM (9-wire) is a trademark owned by Link Evolution Corporation and is used by TOSHIBA TEC under license.

IrDA Protocol Stack Deep CoreTM © Link Evolution Corp. All Rights Reserved.

The B-415-GH25-QM is equipped with a wireless communication device, TEC-BTM. Please be sure to read the enclosed Precautions for Handling of Wireless Communication Devices before using this product.

VORSICHT:

Schallemission: unter 70dB (A) nach DIN 45635 ( oder ISO 7779)

Die für das Gerät Vorgesehene Steckdose muß in der Nähe des Gerätes und leicht zugänglich sein.

For AU EMC

Copyright © 2003

by TOSHIBA TEC CORPORATION All Rights Reserved

570 Ohito, Ohito-cho, Tagata-gun, Shizuoka-ken, JAPAN

Image 2
Contents Series CE Compliance for EU only FCC NoticeSafety Summary For safety Safety Summary Precautions Table of Contents Applicable Model AccessoriesIntroduction 1 5 G H 2 4 Q MIrDA Interface SpecificationsPrinter Radio Interface for GH34 model Bluetooth Interface for GH25 modelSerial Interface RS-232C for GH24 and GH34 models Option BatteryExternal DC Input Media Receipt/LinerlessFront/Rear View Description of Switch/ButtonAppearance Description of LED LampLoading and Removing the Battery Battery PerformanceTo Charge the Battery Pack Attaching the Shoulder Strap Charging timeSET UP Procedure Requirements for OperationHow to Load the Liner Backed Label Roll Loading the LabelStrip Issue Batch IssueHow to Load the Linerless Label Roll How to remove the liner backed label rollHow to remove the linerless label roll Issuing the Media For GH25 model SELF-DIAGNOSTIC Test PrintFor GH24 and GH34 models E9-2 CARE/HANDLING of the Media General Maintenance CleaningCovers and Operation Panel Removing Jammed MediaLED Display and Troubleshooting SecError Process Page