Toshiba B-415 owner manual Safety Summary

Page 3

Safety Summary

ENGLISH VERSION EO1-33014

 

 

The B-415-GH25-QM is equipped with a wireless communication device, TEC-BTM. Please be sure to read the enclosed Precautions for Handling of Wireless Communication Devices before using this product.

Precautions for Handling of Wireless Communication Devices

Bluetooth® Module: TEC-BTM

Trade Mark

Bluetooth is a trademark owned by Bluetooth SIG, Inc. and used by TOSHIBA TEC CORPORATION under license from Japan Total Design Communication Co., Ltd.

The B-415-GH25-QM is equipped with a certified wireless communication module (TEC-BTM). The following cautions are applied to the certified wireless module.

Cautions

General

For all countries and areas

This product is a wireless communication device, and the use of this product is restricted to the following countries or areas. If the product is used in the countries or areas other than the following, you may be punished according to the laws of those countries or areas.

Japan, USA, Canada, Austria, Belgium, Denmark, Finland, France, Germany, Greece, Italy, Ireland, Luxembourg, Portugal, Spain, Sweden, The Netherlands, United Kingdom, Australia, New Zealand, Mexico, Switzerland, Norway, Iceland, Hungary, Liechtenstein

For Europe

Hereby, TOSHIBA TEC CORPORATION, declares that this TEC-BTM is in compliance with the essential requirements and other relevant provisions of Directive 1999/5/EC.

This equipment uses a radio frequency band that has not been harmonised throughout all EU and EFTA countries, and can be used in the following countries.

Austria, Belgium, Denmark, Finland, France, Germany, Greece, Italy, Ireland, Luxembourg, Portugal, Spain, Sweden, The Netherlands, United Kingdom, Switzerland, Norway, Iceland, Hungary, Liechtenstein

For USA

This device complies with Part 15 of the FCC Rules.

Operation is subject to the following two conditions:

(1)this device may not cause harmful interference, and

(2)this device must accept any interference received, including interference that may cause undesired operation.

Changes or modification not expressly approved by manufacturer for compliance could void the user’s authority to operate the equipment.

For Canada

Operation is subject to the following two conditions:

(1)this device may not cause interference, and

(2)this device must accept any interference, including interference that may cause undesired operation of the device.

(i)

Image 3
Contents Series FCC Notice CE Compliance for EU onlySafety Summary For safety Safety Summary Precautions Table of Contents 1 5 G H 2 4 Q M AccessoriesIntroduction Applicable ModelSpecifications PrinterIrDA Interface Bluetooth Interface for GH25 model Serial Interface RS-232C for GH24 and GH34 modelsRadio Interface for GH34 model Battery External DC InputOption Receipt/Linerless MediaDescription of LED Lamp Description of Switch/ButtonAppearance Front/Rear ViewBattery Performance Loading and Removing the BatteryTo Charge the Battery Pack Charging time Attaching the Shoulder StrapRequirements for Operation SET UP ProcedureLoading the Label How to Load the Liner Backed Label RollBatch Issue Strip IssueHow to remove the liner backed label roll How to Load the Linerless Label RollHow to remove the linerless label roll Issuing the Media SELF-DIAGNOSTIC Test Print For GH24 and GH34 modelsFor GH25 model E9-2 CARE/HANDLING of the Media Cleaning General MaintenanceRemoving Jammed Media Covers and Operation PanelSec LED Display and TroubleshootingError Process Page