Toshiba B-415 owner manual Safety Summary

Page 5

Safety Summary

ENGLISH VERSION EO1-33014

 

 

Safety Summary

Personal safety in handling or maintaining the equipment is extremely important. Warnings and Cautions necessary for safe handling are included in this manual. All warnings and cautions contained in this manual and written inside or outside of the printer should be read and understood before handling or maintaining the equipment.

Do not attempt to effect repairs to this equipment. If a fault occurs that cannot be rectified using the proce- dures described in this manual, turn off the power, then contact your authorised TOSHIBA TEC repre- sentative for assistance.

Safety Precautions

This Owner's Manual and the products (machines) which you have purchased contain indications which should be observed in order to use the machines safely and prevent harm to yourself and others and damage to property. The meanings of these indications and symbols are given below.

Read these indications and become familiar with their contents before reading this Owner's Manual.

WARNING This indicates that there is the risk of death or serious injury if the machines are improperly handled contrary to this indication.

If water or any other liquid enters the machine, turn off the power. Continuous use of the machine under such conditions may cause fire or electric shock.

If the equipment enclosed is damaged when dropped or subject to shock, turn off the power. Continu- ous use of the machine under such conditions may cause fire or electric shock.

Avoid continuous exposure to direct sunlight or high temperature as this may cause fire.

Do not remove covers or modify the machine by yourself. Doing so may cause fire or electric shock.

Avoid water, operation with wet hands or cleaning with a moistened cloth. Failure to do this may cause fire or electric shock.

Do not wipe the machine with a cloth moistened with thinner or other volatile solvent as this may cause fire or electric shock.

Use the specified battery only. Failure to do this may cause fire or electric shock.

Danger of explosion if the battery is incorrectly replaced. Replace the battery only with 'TOSHIBA TEC Corporation, Battery Pack Type B-415-BT, 7.2 V 3000 mAh Li-ion'.

Discard used batteries according to the manufacturer's instruction.

ATTENTION:

II ya denger d'explosion s'il ya remplacement incorrect de la batterrie.

Remplacer uniquement avec une batterie du même type ou d'un type équivalent recommandé par le constructeur.

Mettre au rebut les batteries usagées conformément aux instructions du fabricant.

Do not disassemble and modify the battery because it has a protection unit in it. Doing so may break the protection unit, causing the battery to heat up, burst or burn.

If the battery gets wet, dry it completely. Using a wet battery may cause fire or electric shock.

Be aware of the following precautions when using batteries. Otherwise they could heat up, burst or burn.

Do not throw the battery into fire or heat it with a microwave or oven, etc.

Do not load the battery with the electrodes reversed.

Do not connect the electrodes with metal objects like wire. Do not carry or store the battery along with metal objects such as necklaces, hairpins, etc.

Do not stick a needle into, hammer, step on, or drop the battery.

Do not solder the battery.

Do not leave the battery where the temperature is more than 60° centigrade, such as inside a car or in direct sunlight.

(iii)

Image 5
Contents Series FCC Notice CE Compliance for EU onlySafety Summary For safety Safety Summary Precautions Table of Contents Introduction AccessoriesApplicable Model 1 5 G H 2 4 Q MIrDA Interface SpecificationsPrinter Radio Interface for GH34 model Bluetooth Interface for GH25 modelSerial Interface RS-232C for GH24 and GH34 models Option BatteryExternal DC Input Receipt/Linerless MediaAppearance Description of Switch/ButtonFront/Rear View Description of LED LampBattery Performance Loading and Removing the BatteryTo Charge the Battery Pack Charging time Attaching the Shoulder StrapRequirements for Operation SET UP ProcedureLoading the Label How to Load the Liner Backed Label RollBatch Issue Strip IssueHow to remove the liner backed label roll How to Load the Linerless Label RollHow to remove the linerless label roll Issuing the Media For GH25 model SELF-DIAGNOSTIC Test PrintFor GH24 and GH34 models E9-2 CARE/HANDLING of the Media Cleaning General MaintenanceRemoving Jammed Media Covers and Operation PanelSec LED Display and TroubleshootingError Process Page