Toshiba 1000 manual EPO Port emergency power off, Network Transient Protector, Load Segments

port cannot be used when using the USB port. The USB cable is a standard cable and may be purchased separately.

5.4EPO Port (emergency power off)

A customer-supplied switch located remotely may be used to open the EPO connection and force the UPS output receptacles to be switched off. The EPO function shuts down the equipment immediately. An EPO will not provide an orderly shutdown. The UPS will have to be manually restarted in order to regain power to the outlets.

After an Emergency Power Off (EPO), do not reset the breaker until the UPS has been fully discharged. The UPS could be damaged if the unit is not fully discharged before the breaker is reset.

5.5Network Transient Protector

The network transient protector, located on the back panel, has both IN and OUT RJ45 10 baseT jacks and will protect a single network connector. Connect the input connector to the jack labeled IN, and the output connector to the jack labeled OUT.

5.6Load Segments

The sets of receptacles known as load segments provide organized shutdown and startup of the equipment. Less critical equipment can be turned off during power outages saving battery power for critical loads. The load group status can be viewed from the LCD display and can be changed if necessary.

Load	10%	20%	30%	40%	50%	60%	70%	80%	90%	100%
1000VA Backup (min)	150	56	38	30	23	19	15	12	10	7
1500VA Backup (min)	80	37	21	19	18	15	13	11	8	6
2000VA Backup (min)	150	68	38	26	19	14	11	9	8	7
3000VA Backup (min)	80	40	25	19	15	12	9	8	7	6

16