AMT Datasouth 5106 manual Mechanical Adjustments to the Thermal Head

Page 19

5.0MECHANICAL ADJUSTMENTS TO THE THERMAL HEAD

If you have encountered print quality problems on the left or right side of your labels, the following adjustments may help.

1.Have both a phillips and a slotted screwdriver available. The phillips screwdriver is used for loosening and tightening screws while the slotted screwdriver is used to adjust the position of moveable parts.

2.Loosen phillips screw(s) slightly to allow movement which holds the adjustable part.

3.Use the slotted screwdriver as a wedge or fulcrum to turn or push lightly on the part you are attempting to adjust.

4.Once you have made the adjustment, hold the position of the adjustment while tightening the phillips screw(s).

Figure 6. Mechanical Adjustment

11

Page 18 Page 20
Image 19
Page 18 Page 20
Contents CodeWriter Technical Reference AMT Datasouth Corp AMT Datasouth CodeWriter 5106 Disclaimer of Warranties Copyright Notice Page Page Table of Figures Page General Information FeaturesRibbon Specifications 5106 Overall DimensionsAssembly and Setup Procedure Initial SetupSelection of Media Output Mode MODE/MENU Parameter Setting ModeParameter Tree Version Loading INK Ribbon and Label Roll ∙ If outside winding label roll is used Thermal Head Replacement AdjustmentsChanging the Direction of the Take-up Roller Thermal Head Block Thermal Head PositioningMechanical Adjustment Mechanical Adjustments to the Thermal HeadPage Page Page Page Page Ribbon Ribbon AdjustmentPage Wrinkle On Ribbon Running ConditionPage Sensor Type and Functions SensorsSensitivity Adjustment Name Electrical Circuitry External Connector and PIN Assignments Usage and Adjusted By Voltage Check and AdjustmentMain PCB Board Voltage Adjusted ByTAKE-UP Motor Connectors
Top Page Image Contents