AMT Datasouth 5106 manual Thermal Head Positioning, Thermal Head Block

Page 18

4.3Thermal Head Positioning

If you have replaced the thermal head, positioning should be checked. Verify the ribbon running condition as well.

Note:

Make sure of the following prior to the adjustment:

∙Power off the printer

∙Use full width media (labels) 5.2 in./132 mm) when checking.

∙Rotate the head pressure screw clockwise completely.

Figure 5. Thermal Head Block

10

Image 18

Contents CodeWriter Technical Reference AMT Datasouth Corp AMT Datasouth CodeWriter 5106 Disclaimer of Warranties Copyright Notice Page Page Table of Figures Page Features General Information5106 Overall Dimensions Ribbon SpecificationsInitial Setup Assembly and Setup ProcedureSelection of Media Output Mode Parameter Setting Mode MODE/MENUParameter Tree Version Loading INK Ribbon and Label Roll ∙ If outside winding label roll is used Adjustments Thermal Head ReplacementChanging the Direction of the Take-up Roller Thermal Head Positioning Thermal Head BlockMechanical Adjustments to the Thermal Head Mechanical AdjustmentPage Page Page Page Page Ribbon Adjustment RibbonPage Running Condition Wrinkle On RibbonPage Sensors Sensor Type and FunctionsSensitivity Adjustment Name Electrical Circuitry External Connector and PIN Assignments Voltage Check and Adjustment Usage and Adjusted ByVoltage Adjusted By Main PCB BoardTAKE-UP Motor Connectors