AMT Datasouth 5106 manual

Page 28

3.Slightly loosen the right hex head screw which fixes the ribbon applicator to the front side. Then fix the applicator again. This gives the right side of the ribbon more tension by changing position of the ribbon applicator.

Figure 14. Ribbon Application Adjustment

4.Feed some media (labels) until the wrinkles on the ribbon are removed. Then issue ten (10) media samples (labels) for inspection. If the wrinkles are produced again, repeat the above procedure.

20

Image 28

Contents CodeWriter Technical Reference AMT Datasouth Corp AMT Datasouth CodeWriter 5106 Disclaimer of Warranties Copyright Notice Page Page Table of Figures Page Features General Information5106 Overall Dimensions Ribbon SpecificationsAssembly and Setup Procedure Initial SetupSelection of Media Output Mode Parameter Setting Mode MODE/MENUParameter Tree Version Loading INK Ribbon and Label Roll ∙ If outside winding label roll is used Adjustments Thermal Head ReplacementChanging the Direction of the Take-up Roller Thermal Head Positioning Thermal Head BlockMechanical Adjustments to the Thermal Head Mechanical AdjustmentPage Page Page Page Page Ribbon Adjustment RibbonPage Running Condition Wrinkle On RibbonPage Sensors Sensor Type and FunctionsSensitivity Adjustment Name Electrical Circuitry External Connector and PIN Assignments Voltage Check and Adjustment Usage and Adjusted ByVoltage Adjusted By Main PCB BoardTAKE-UP Motor Connectors