AMT Datasouth 5106 manual Main PCB Board, Voltage Adjusted By

Page 35

12.0 MAIN PCB BOARD

Check	Typ.	Usage and
Terminal	Voltage	Adjusted By

		For logic circuit
Vcc	+ 5.0	No adjustment volume

		For RS-232 interface
V-	- 12.0	No adjustment volume

		For RS-232 interface
V+	+ 12.5	No adjustment volume

		For Thermal Head, DC motor and ribbon
VTH	+ 24.0	solenoid
		RV1 on switching power supply unit
		(PTR637-30)
		For Stepping Motor
VSP	+ 36.0	RV1 on switching power supply unit
		(PTR637-30)

NOTE:

Check the voltage of VSP and VT H before you adjust the voltages by RV1. RV1 adjusts both voltages simultaneously.

27

Image 35

Contents CodeWriter Technical Reference AMT Datasouth Corp AMT Datasouth CodeWriter 5106 Disclaimer of Warranties Copyright Notice Page Page Table of Figures Page General Information FeaturesRibbon Specifications 5106 Overall DimensionsSelection of Media Output Mode Initial SetupAssembly and Setup Procedure MODE/MENU Parameter Setting ModeParameter Tree Version Loading INK Ribbon and Label Roll ∙ If outside winding label roll is used Thermal Head Replacement AdjustmentsChanging the Direction of the Take-up Roller Thermal Head Block Thermal Head PositioningMechanical Adjustment Mechanical Adjustments to the Thermal HeadPage Page Page Page Page Ribbon Ribbon AdjustmentPage Wrinkle On Ribbon Running ConditionPage Sensor Type and Functions SensorsSensitivity Adjustment Name Electrical Circuitry External Connector and PIN Assignments Usage and Adjusted By Voltage Check and AdjustmentMain PCB Board Voltage Adjusted ByTAKE-UP Motor Connectors