Topcon CT-80, COMPUTERIZED TONOMETER instruction manual Format

⋅ Communication format	Format: OFF, MODE 1, MODE 2, MODE 3, MODE 4,
(FORMAT)	STD 1 (For shipment, “OFF” is set.)
	MODE 1: When	is pressed, communication is done
	after printing.
	MODE 2: Data communication is done every measure-
	ment.
	MODE 3: When	is pressed, communication is done
	without printing.
	MODE 4: When	is pressed, communication is done
	without printing.
	STD 1: When	is pressed, communication is done
	after printing.

When Mode 1, 2 or 3 is set, data is transmitted automatically without confirmation from the receiver side. When STD 1 is set, communication is controlled by RTS-CTS.

Under the RTS-CTS control, if no CS (CTS) signal is returned from the receiver side,

transmission can be canceled by pressing . Also, if no DR (DSR) signal is re- turned, it is recognized as a communication failure and FAIL is displayed on the monitor screen.

⋅ Communication speed (SPEED) Baud rate: 2400, 9600 (bps) (For shipment,

2400bps is set.)

51

REFERENCE