D-Link DWA-140 manual Static Routing menu

Static Routing

Use Static Routing to specify a route used for data traffic within your Ethernet LAN or to route data on the WAN. This is used to specify that all packets destined for a particular network or subnet use a predetermined gateway.

Figure 4-11. Static Routing menu

To add a static route, choose a connection from the pull-down menu and then enter a New Destination IP address, subnet Mask, Gateway IP address and Metric value. Click Apply to enter the new static route in the table below. The route becomes active immediately upon creation.

To remove a static route from the table in the bottom half of the window, choose to Delete it from the table and click the Apply button. Remember to save the configuration changes.

53