Reference Manual for the NETGEAR ProSafe Dual Band Wireless Access Point WAG302
–11g Only – Only 802.11g wireless stations can be used.
–11b Only – All 802.11b wireless stations can be used. 802.11g wireless stations can still be used if they can operate in 802.11b mode.
•Channel/Frequency: Select the channel you wish to use on your wireless LAN. The wireless channel in use will be between 1 to 11 for US and Canada, 1 to 13 for Europe and Australia. The default is channel 11.
It should not be necessary to change the wireless channel unless you experience interference (shown by lost connections and/or slow data transfers). Should this happen, you may need to experiment with different channels to see which is the best. See “Wireless Channels” on page
Note: This feature will be disabled if AutoCell is enabled. Channel selection is automatically adjusted by AutoCell when the Auto RF Management option is enabled. The default setting is for the AutoCell Auto RF Management option to be enabled.
–Access points use a fixed channel. You can select the channel used. This allows you to choose a channel which provides the least interference and best performance. In the USA and Canada, 11 channels are available.
Note: Channel 6 is required for 108 Mbps data rate.
–If using multiple access points, it is better if adjacent access points use different channels to reduce interference. The recommended channel spacing between adjacent access points is 5 channels (for example, use channels 1 and 6, or 6 and 11).
–In “Infrastructure” mode, wireless stations normally scan all channels, looking for an access point. If more than one access point can be used, the one with the strongest signal is used. This can only happen when the various access points are using the same SSID.
•Data Rate: Shows the available transmit data rate of the wireless network. The possible data
rates supported are: 1 Mbps, 2 Mbps, 5.5 Mbps, 11 Mbps, 12 Mbps, 24 Mbps, 36 Mbps, 48 Mbps, 54 Mbps and 108 Mbps.
Note: The 108 Mbps option is available when the Channel/Frequency is set to channel 6 and the operating mode is set to 11g Only. The default is Best.
•Output Power: Shows the available transmit power of the access point. The possible Tx
power options are: Full, 50%, 25%, 12.5%, and minimum. The transmit power may varies depends on the local regulatory regulations. Note that this feature will be disabled if AutoCell is enabled. The default is Full.
Basic Installation and Configuration |