NETGEAR WAG302 manual Field Description Access Point Information, Current IP Settings

Reference Manual for the NETGEAR ProSafe Dual Band Wireless Access Point WAG302

This screen shows the following parameters:

Table 4-1.	General Information Fields
Field		Description
Access Point Information
Access Point Name		The default name may be changed if desired.
(NetBIOS name)
MAC Address		Displays the Media Access Control address (MAC address) of the wireless
		access point’s Ethernet port.
Country/Region		Displays the domain or region for which the wireless access point is
		licensed for use. It may not be legal to operate this wireless access point in
		a region other than one of those identified in this field.
Firmware Version		The version of the firmware currently installed.
Current IP Settings
IP Address		The IP address of the wireless access point.
Subnet Mask		The subnet mask for the wireless access point.
Default Gateway		The default gateway for the wireless access point communication.
DHCP Client		Enabled indicates that the current IP address was obtained from a DHCP
		server on your network. Disabled indicated a static IP configuration.
Current Wireless Settings 11a
Access Point Mode		Identifies the operating mode of the WAG302: Access Point, Point-to-point
		bridge, Multi-point bridge or Repeater.
Operating Mode		Identifies the 802.11 operating mode of the WAG302.
Wireless Network Name		Displays the wireless network name (SSID) being used by the wireless port
(SSID)		of the wireless access point. The default is NETGEAR_11a.
Channel/Frequency		Identifies the channel the wireless port is using. 52 is the default channel
		setting. See “Wireless Channels” on page B-7for the frequencies used
		on each channel.
WEP/WPA		WEP/WPA setting.

4-6 Management

202-10078-01