Aruba Networks Aruba AP 60/61 manual 1Provisioning Tab

Page 14

Provisioning Access Points

Chapter 2

FIGURE 2-1Provisioning Tab

2.Configure the APs Subnet and Netmask.

This is the subnet from which the AP gets an IP during provisioning. (This is not the IP address the AP will use when deployed. The provisioning subnet should be not be the same as an existing subnet on Mobility Controller.)

3.Select the Port or Port range for provisioning.

To set the Port Range, select the first and the last ports of your range. All the ports in between are automatically selected. (Ports have to be sequentially assigned.)

4.Enter the required information and click Enable.The Port Range screen displays.

10 Aruba AP 60/61	0500160
Installation Guide	December 2005

Image 14

Contents Aruba AP 60/61 Access Point Aruba Wireless Networks, Inc. All rights reserved TrademarksContents Appendix B Port Specifications Introduction1 Antenna fixtures for Wireless Communications Front ViewState Description Indicator LEDs1Aruba AP 60/61 LEDs Air VentsDC Power Socket FE PortBack View Mounting SlotsKensington Security Slot Aruba AP Setup ProcessFold-Out Stand Provisioning Access Points Aruba Discovery Protocol AP Provisioning AP Reprovisioning1Provisioning Tab 2Port Range Screen Manual Provisioning RequirementsProvisioning Access Points Connecting the Console Terminal Console Access to the AP1Console Terminal Settings Dram 32 MB Setting Aruba AP 60/61 Parameters Apboot setenv servername aruba-masterMy network uses direct IP addresses instead of DNS Apboot save apboot boot Provisioning Access Points AP Deployment Mounting the Aruba AP 60/61Aruba 60 Detachable Antennas 1Aruba AP 60/61 Mounting Options1FCC-Approved Detachable Antennas Aruba Description Gain Manufacturer DbiAP-ANT-8 Free-Standing Placement 2Aruba AP 60/61Fold-Out StandUsing the Built-In Mounting Slots 3Mounting Screw SpecificationsUsing the Optional Mounting Kits 4Hanging the Aruba AP 60/61 on ScrewsConnecting Required Cables Selecting an FE CableConnecting Cables & Power Maintenance Selecting an AntennaAccessing the AP Support Prompt Direct Spoe Connection to Mobility ControllerBaud Rate Data Bits Parity Stop Bits Flow Control 9600 None Table A-1Console Terminal SettingsDirect Terminal Connection Setting Telnet Access Remote Telnet ConnectionPrivileged Commands Access LevelsUser Commands AP SupportResetting the AP to Factory Defaults Troubleshooting FE Port Figure B-1Aruba AP 60/61 FE PortSerial Breakout Adapter DB-9 SpecificationTable B-1Console Terminal Settings To AP Specifications To Network SpecificationsPort Specifications FCC Class B ComplianceUnited States Radio Frequency Interference Requirements CanadaRF Radiation Exposure Statement RSS-210Indoor Restriction for 5GHz Frequency Range Vcci Class B JapanEurope Product Specifications Certifications MeasurementProduct Label Product FeaturesRadio Characteristics Ethernet CompatibilityPhysical Description Power Over EthernetPackage Contents Optional ItemsAruba AP-60 Access Point Figure C-1Part Number AP-60Table C-1AP-60 802.11 Specifications Description 802.11a 802.11b 802.11gAble C-1 AP-60 802.11 Specifications ACKAble C-2 AP-60 Characteristics BssidAP-60 Characteristics Aruba AP-61 Access Point Table C-2AP-60 CharacteristicsTable C-3AP-61 802.11 Specifications Able C-3 AP-61 802.11 Specifications Able C-4 AP-61 CharacteristicsAble C-4 AP-61 Characteristics Table C-4AP-61 Characteristics Related DocumentsText Conventions Table C-5Text ConventionsTable C-5Text Conventions Contacting Aruba Networks Telephone NumbersProper Disposal of Aruba Equipment Product Specifications Aruba AP 60/61 W . a r u b a n e t w o r k s . c o m