Aruba Networks Aruba AP 60/61 manual To AP Specifications, To Network Specifications

Page 43

Port Specifications

Appendix B

“To AP” Specifications

The RJ-45 connector labeled “To AP” attaches to the Aruba AP 60/61 FE port either directly (if the AP is physically available) or indirectly (if the AP is already deployed).

When connecting indirectly, use a straight-through FE coupler to attach the “To AP” connector to the FE cable leading directly to the AP’s FE port with no intervening hubs, routers, or other network equipment. The cable must be

8-conductor, Category 5 UTP, straight-through FE cable with a maximum length of 100 meters (325 feet).

The Aruba AP 60/61 and serial breakout adapter are plenum rated. When is installed in an air-handling space, as described in NEC (2002) Article 300.22(C), any connecting FE cable should be suitable under NEC Article 800.50 and marked accordingly for use in plenums and air-handling spaces with regard to smoke propagation, such as CL2-P, CL3-P, MPP or CMP.

Install cables in accordance with all applicable local regulations and practices.

“To Network” Specifications

The RJ-45 connector labeled “To Network” attaches to an FE LAN segment. This connection is optional unless IEEE 802.11af Power Over Ethernet (POE) is used to power the AP during manual provisioning.

A straight-through FE coupler may be used to attach the “To Network” connector to a LAN FE cable. The appropriate cable depends on the level of connectivity required of the FE port:

zIf the connecting device supports IEEE 802.3af Power Over Ethernet (POE), use a 4- or 8-conductor, Category 5 UTP, straight-through FE cable with male RJ-45 connectors.

The Aruba 5000 (with Line Card LC-5000-24FE-2GE-SPOE), the Aruba 2400, and the Aruba 800 support SPOE.

zOtherwise, use a 4- or 8-conductor, Category 5 UTP, FE cable with male RJ-45 connectors. The port detects MDI/MDX and automatically adjusts for straight-through or crossover cables.

NOTE: Only IEEE 802.3af Power Over Ethernet is supported for manual provisioning. “Inline” or “midspan” POE devices will not work with the Aruba serial breakout adapter.

The maximum length for FE cables is 100 meters (325 feet).

Aruba AP 60/61 39

Installation Guide

Image 43

Contents Aruba AP 60/61 Access Point Trademarks Aruba Wireless Networks, Inc. All rights reservedContents Appendix B Port Specifications Introduction1 Front View Antenna fixtures for Wireless CommunicationsAir Vents Indicator LEDs1Aruba AP 60/61 LEDs State DescriptionFE Port DC Power SocketMounting Slots Back ViewFold-Out Stand Aruba AP Setup ProcessKensington Security Slot Provisioning Access Points Aruba Discovery Protocol AP Reprovisioning AP Provisioning1Provisioning Tab 2Port Range Screen Requirements Manual ProvisioningProvisioning Access Points Console Access to the AP Connecting the Console Terminal1Console Terminal Settings Dram 32 MB Apboot setenv servername aruba-master Setting Aruba AP 60/61 ParametersMy network uses direct IP addresses instead of DNS Apboot save apboot boot Provisioning Access Points Mounting the Aruba AP 60/61 AP Deployment1Aruba AP 60/61 Mounting Options Aruba 60 Detachable AntennasAruba Description Gain Manufacturer Dbi 1FCC-Approved Detachable AntennasAP-ANT-8 2Aruba AP 60/61Fold-Out Stand Free-Standing Placement3Mounting Screw Specifications Using the Built-In Mounting Slots4Hanging the Aruba AP 60/61 on Screws Using the Optional Mounting KitsSelecting an FE Cable Connecting Required CablesConnecting Cables & Power Selecting an Antenna MaintenanceDirect Spoe Connection to Mobility Controller Accessing the AP Support PromptDirect Terminal Connection Table A-1Console Terminal SettingsBaud Rate Data Bits Parity Stop Bits Flow Control 9600 None Remote Telnet Connection Setting Telnet AccessAP Support Access LevelsUser Commands Privileged CommandsResetting the AP to Factory Defaults Troubleshooting Figure B-1Aruba AP 60/61 FE Port FE PortTable B-1Console Terminal Settings DB-9 SpecificationSerial Breakout Adapter To Network Specifications To AP SpecificationsPort Specifications United States ComplianceFCC Class B RSS-210 CanadaRF Radiation Exposure Statement Radio Frequency Interference RequirementsEurope JapanIndoor Restriction for 5GHz Frequency Range Vcci Class B Product Specifications Measurement CertificationsEthernet Compatibility Product FeaturesRadio Characteristics Product LabelOptional Items Power Over EthernetPackage Contents Physical DescriptionFigure C-1Part Number AP-60 Aruba AP-60 Access PointDescription 802.11a 802.11b 802.11g Table C-1AP-60 802.11 SpecificationsACK Able C-1 AP-60 802.11 SpecificationsBssid Able C-2 AP-60 CharacteristicsAP-60 Characteristics Table C-2AP-60 Characteristics Aruba AP-61 Access PointTable C-3AP-61 802.11 Specifications Able C-4 AP-61 Characteristics Able C-3 AP-61 802.11 SpecificationsAble C-4 AP-61 Characteristics Related Documents Table C-4AP-61 CharacteristicsTable C-5Text Conventions Text ConventionsTable C-5Text Conventions Telephone Numbers Contacting Aruba NetworksProper Disposal of Aruba Equipment Product Specifications Aruba AP 60/61 W . a r u b a n e t w o r k s . c o m